Qtech QSW-8200-52T-AC [22/36] Mrpp ring secondary port

User Manual

Chapter 3. Commands for MRPP 22

www.qtech.ru

 Function: Specify MRPP ring primary-port.

 Parameter: <ring-id> is the ID of MRPP ring; range is <1-4096>.

 Command Mode: Port mode

 Default: None

 Usage Guide: The command specifies MRPP ring primary port. Primary node uses

primary port to send Hello packet, secondary port is used to receive Hello packet from

primary node. There are no difference on function between primary port and

secondary of secondary node.

 The mrpp enable command must be enabled before the control-vlan command be

used. If primary port, secondary port, node-mode and enable commands all be

configured after control-vlan, then the mrpp-ring function is enabled.

 Example: Configure the primary of MRPP ring 4000 to Ethernet 1/0/1.

 Switch(Config)#interface ethernet 1/0/1

 Switch(config-If-Ethernet1/0/1)#mrpp ring 4000 primary-port

3.14 mrpp ring secondary-port

 Command: mrpp ring < ring-id > secondary-port

 no mrpp ring < ring-id > secondary-port

 Function: Specify secondary of MRPP ring.

 Parameter: <ring-id> is the ID of MRPP ring; range is <1-4096>.

 Command Mode: Port mode

 Default: None

 Usage Guide: The command specifies secondary port of MRPP ring. The primary node

uses secondary port to receive Hello packet from primary node. There are no difference

on function between primary port and secondary of secondary node.

 The mrpp enable command must be enabled before the control-vlan command be

used. If primary port, secondary port, node-mode and enable commands all be

configured after control-vlan, then the mrpp-ring function is enabled.

 Example: Configure secondary port of MRPP ring to 1/0/3.

 Switch(config)#interface ethernet1/0/3

 Switch(Config-If-Ethernet1/0/3)#mrpp ring 4000 secondary-port

3.15 node-mode

 Command: node-mode {maser | transit}

 Function: Configure the type of the node to primary node or secondary node.

 Parameter: None.

 Command Mode: MRPP ring mode.

 Default: Default the node mode is secondary node.

 Usage Guide: None.

 Example: Configure the switch to primary node. MRPP ring 4000.