Qtech QSW-8200-52T-AC [24/36] Chapter 4 commands for ulpp

User Manual

Chapter 4. Commands for ULPP 24

www.qtech.ru

Chapter 4 COMMANDS FOR ULPP

4.1 clear ulpp flush counter interface

 Command: clear ulpp flush counter interface <name>

 Function: Clear the statistic information of the flush packets.

 Parameter: <name> is the name of the port.

 Default: None.

 Command mode: Admin mode.

 Usage Guide: None.

 Example: Clear the statistic information of the flush packets for the port1/0/1.

 Switch#clear ulpp flush counter interface e1/0/1

 ULPP flush counter has been reset.

4.2 control vlan

 Command: control vlan <integer>

 no control vlan

 Function: Configure the control VLAN of ULPP group; the no command restores the

default value.

 Parameter: <integer> is the control VLAN ID that sends the flush packets, range from 1

to 4094.

 Default: The default is VLAN 1.

 Command mode: ULPP group configuration mode.

 Usage Guide: Configure the control VLAN of ULPP group. This VLAN must correspond

the existent VLAN, after it is configured, this VLAN can’t be deleted. It must belong to

the VLAN protected by ULPP group to avoid flush packets loopback.

 Example: Configure the sending control VLAN of ULPP group as 10.

 Switch(config)# ulpp group 20

 Switch(ulpp-group-20)# control vlan 10

4.3 debug ulpp error

 Command: debug ulpp error

 no debug ulpp error

 Function: Show the error information of ULPP. The no operation disables showing the

error information of ULPP.

 Parameter: None.

 Default: Do not display.

 Command mode: Admin mode.

 Usage Guide: None.