Qtech QSW-8200-52T-AC [31/36] Ulpp control vlan

User Manual

Chapter 4. Commands for ULPP 31

www.qtech.ru

 Preemption delay: 30s

 Control VLAN:1

 Protected VLAN: Reference Instance 1

 Member Role State

 --------------------------------------------------------------

 Ethernet1/0/1 MASTER FORWARDING

 Ethernet1/0/2 SLAVE STANDBY

4.20 ulpp control vlan

 Command: ulpp control vlan <vlan-list>

 no ulpp control vlan <vlan-list>

 Function: Configure the receiving control VLANs of the port, the no command restores

the default value.

 Parameter: <vlan-list> specify the control VLAN list that receives the flush packets,

such as: i; j-k. The number of VLANs in Each character string can not exceed 100. The

receiving control VLAN of the port can be added.

 Default: The default is VLAN 1.

 Command mode: Port mode.

 Usage Guide: Configure the receiving control VLAN for the port. This VLAN must

correspond the existent VLAN, after it is configured, this VLAN can’t be deleted.

 Example: Configure the receiving control VLAN as 10.

 Switch(config)# interface ethernet 1/0/1

 Switch(config-If-Ethernet1/0/1)# ulpp control vlan 10

4.21 ulpp flush disable arp

 Command: ulpp flush disable arp

 Function: Disable receiving the flush packets of deleting ARP.

 Parameter: None.

 Default: By default, disable receiving the flush packets of deleting ARP.

 Command mode: Port mode.

 Usage Guide: If this command is configured, then it will not receive the flush packets of

deleting ARP.

 Example: Disable receiving the flush packets of deleting ARP.

 Switch(config)# interface ethernet 1/0/1

 Switch(config-If-Ethernet1/0/1)# ulpp flush disable arp

4.22 ulpp flush disable mac

 Command: ulpp flush disable mac

 Function: Disable receiving the flush packets of updating MAC address.