Qtech QSW-8200-52T-AC [17/36] Chapter 3 commands for mrpp

User Manual

Chapter 3. Commands for MRPP 17

www.qtech.ru

Chapter 3 COMMANDS FOR MRPP

3.1 control-vlan

 Command: control-vlan <vid>

o no control-vlan

 Function: Configure control VLAN ID of MRPP ring; the “no control-vlan” command

deletes control VLAN ID.

 Parameter: <vid> expresses control VLAN ID, the valid range is from 1 to 4094.

 Command Mode: MRPP ring mode

 Default: None

 Usage Guide: The command specifies Virtual VLAN ID of MRPP ring, currently it can be

any value in 1-4094. To avoid confusion, it is recommended that the ID is non-

configured VLAN ID, and the same to MRPP ring ID. In configuration of MRPP ring of the

same MRPP loop switches, the control VLAN ID must be the same, otherwise the whole

MRPP loop may not be able to work normally or form broadcast.

 The mrpp enable command must be start before the control-vlan command be used. If

primary port, secondary port, node-mode and enable commands all be configured after

control-vlan, the mrpp-ring function is enabled.

 Example: Configure control VLAN of mrpp ring 4000 is 4000.

 Switch(config)#mrpp ring 4000

 Switch(mrpp-ring-4000)#control-vlan 4000

3.2 clear mrpp statistics

 Command: clear mrpp statistics [<ring-id>]

 Function: Clear statistic information of MRPP data packet of MRPP ring receiving and

transferring.

 Parameter: <ring-id> is MRPP ring ID, the valid range is from 1 to 4096, if not specified

ID, it clears all of MRPP ring statistic information.

 Command Mode: Admin Mode.

 Default: None.

 Usage Guide: None.

 Example: Clear statistic information of MRPP ring 4000 of switch.

 Switch#clear mrpp statistics 4000

3.3 debug mrpp

 Command: debug mrpp

o no debug mrpp