Kohler Command PRO EFI ECV630 [134/148] Reassembly

Reassembly

134

24 690 02 Rev. MKohlerEngines.com

Install Intake Manifold

Torque Sequence

Intake Manifold Components (ECV EFI)

MAP or TMAP

Sensor

B Fuel Rail C Fuel Injector D Metal Retaining Clip

E Intake Manifold F Wiring Clamp G

Crankshaft Position

Sensor (Earlier

Design Bracket)

Crankshaft Position

Sensor (Later Design

Bracket)

1. Install intake manifold and new gaskets, with wiring

harness attached, to cylinder heads. Slide any wiring

harness clips onto appropriate bolts before installing.

Make sure gaskets are in proper orientation. Using

sequence shown, torque screws in 2 stages, ﬁ rst to

7.8 N·m (69 in. lb.), then to 10.5 N·m (93 in. lb.).

2. Install ground terminal to crankcase post with a

silver screw. Torque to 4.0 N·m (35 in. lb.) into used

holes or 6.2 N·m (55 in. lb.) in new holes.

3. Install wire harness clip to other crankcase post.

Torque to 4.0 N·m (35 in. lb.) into used holes or

6.2 N·m (55 in. lb.) in new holes.

4. Place wire harness conduit in clip and snap clip

together.