Beurer MPE 58 [12/60] What if there are problems

6. What if there are problems?

Problem Possible cause Solution

Device will not switch

on.

Mains plug not plugged in. Insert the mains plug into the socket.

No voltage at mains socket. Check your fusebox.

UV nail gel does not dry. Treatment time with UV light too short. Set a longer UV light treatment time.

Nail varnish does not

dry.

Treatment time in dryer too short. Keep your varnished nails in the dryer for

longer.

UV fluorescent tube

does not light up.

UV fluorescent tube not correctly

inserted.

Check that the UV fluorescent tube has

been correctly inserted.

UV fluorescent tube faulty. Insert a new UV fluorescent tube.

7. Replacement parts and wearing parts

Replacement parts and wearing parts are available from the corresponding service address (according to the

service address list). Please state the corresponding order number.

Designation Item number and/or order number

UV fluorescent tubes, 4 units 163.290

8. Disposal

Observe the local regulations for material disposal. Dispose of the unit in accordance with EC Directive

2002/96/EC – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please

contact the local authorities responsible for waste disposal.

9. Technical data

Model no. MPE 58

Dimensions L220 x W210 x H100 mm

Weight 1632 g

Power supply 220 – 240 V, ~ 50/60 Hz

Nominal power 40 W

Permissible storage conditions Store in a clean and dry place

Number of UV lamps 4

UV lamp type UV-9 W-L 365 nm, 9 W

UV type of device UV-A lamp type 3

Switch-off times 90 seconds, 120 seconds, continuous operation