Defort DGP-600N [5/76] Maintenance instructions
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Defort DGP-600N [5/76] Maintenance instructions

Defort DGP-600N [5/76] Maintenance instructions
5
1. Set up the pump on a : rm and level surface.
2. Fit the suction pipe so it is ready for use.
3. Fill the pump with water through the delivery
pipe connection.
4. Connect the delivery pipe so it is ready for
use. During the priming operation you have to
fully open all the shut-off mechanisms (spray
nozzles, valves) etc. in the delivery line so that
the air in the suction line can escape freely.
5. Make the connections to the electric supply.
6. Turn on the ON/OFF switch (the pilot lamp on
the switch lights up).
7. The initial priming operation can take approx.
0.5 to 5 minutes, depending on the suction
height and amount of air in the suction pipe. If
the priming takes a long time, you will need to
top up again with water.
8. If the water management system is removed
after being used it is essential to : ll it up again
with water when it is reconnected and re-
started.
11. Maintenance instructions
• The pump is basically maintenance free. To
ensure a long service life, however, we recommend
regular checks and care.
Warning!
Before every servicing, switch off the pump and
remove the plug from the socket.
• If the pump is not going to be used for a long
time or has to be removed for the winter months,
rinse it out with water, empty it completely and
allow it to dry.
• If there is a risk of frost, the pump must be
emptied completely.
• After long stoppages, make sure the rotor turns
correctly by brie@ y switching the pump on and off.
• If the pump becomes blocked, connect the
pressure line to the water line and remove the
intake hose. Open the water line. Switch on the
pump several times for approx. 2 seconds. Most
blockages can be removed in this way.
12. Replacing the mains cable
Warning! Disconnect the pump from the mains!
If the mains cable is defective, it must be
replaced by an electrician.
GB

Содержание

Похожие устройства

GB 1 Set up the pump on a firm and level surface Warning 2 Fit the suction pipe so it is ready for use 3 Fill the pump with water through the delivery pipe connection Before every servicing switch off the pump and remove the plug from the socket 4 Connect the delivery pipe so it is ready for use During the priming operation you have to fully open all the shut off mechanisms spray nozzles valves etc in the delivery line so that the air in the suction line can escape freely 5 Make the connections to the electric supply 6 Turn on the ON OFF switch the pilot lamp on the switch lights up 7 The initial priming operation can take approx 0 5 to 5 minutes depending on the suction height and amount of air in the suction pipe If the priming takes a long time you will need to top up again with water 8 If the water management system is removed after being used it is essential to fill it up again with water when it is reconnected and re started If the pump is not going to be used for a long time or has to be removed for the winter months rinse it out with water empty it completely and allow it to dry If there is a risk of frost the pump must be emptied completely After long stoppages make sure the rotor turns correctly by briefly switching the pump on and off If the pump becomes blocked connect the pressure line to the water line and remove the intake hose Open the water line Switch on the pump several times for approx 2 seconds Most blockages can be removed in this way 12 Replacing the mains cable Warning Disconnect the pump from the mains If the mains cable is defective it must be replaced by an electrician 11 Maintenance instructions The pump is basically maintenance free To ensure a long service life however we recommend regular checks and care 5

Скачать