Gigabyte H370 HD3 (rev. 1.0) [32/48] Administratorpassword

& OtherPCIdevices

 AllowsyoutoselectwhethertoenabletheUEFIorLegacyoptionROMforthePCIdevicecontrollerother

than the LAN, storage device, and graphics controllers.

Donotlaunch  DisablesoptionROM.

UEFI    EnablesUEFIoptionROMonly.(Default)

Legacy   EnableslegacyoptionROMonly.

 ThisitemiscongurableonlywhenCSM Support is set to Enabled.

& AdministratorPassword

 Allowsyoutocongureanadministratorpassword.Press<Enter>onthisitem,typethepassword,and

thenpress<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress

<Enter>. You must enter the administrator password (or user password) at system startup and when entering

BIOS Setup. Differing from the user password, the administrator password allows you to make changes to

all BIOS settings.

& User Password

 Allowsyoutocongureauserpassword.Press<Enter>onthisitem,typethepassword,andthenpress

<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress<Enter>.

You must enter the administrator password (or user password) at system startup and when entering BIOS

Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.

To cancel the password, press <Enter> on the password item and when requested for the password, enter

thecorrectonerst.Whenpromptedforanewpassword,press<Enter>withoutenteringanypassword.

Press<Enter>againwhenpromptedtoconrm.

 NOTE:BeforesettingtheUserPassword,besuretosettheAdministratorPasswordrst.

- 32 -