Planet IPX-1803 [19/49] Reload ip pbx configuration

PLANET IPX-1800 user’s manual

registration admission control to limit the maximum number of actively registered clients. Max

active calls is for call admission control to limit the maximum number of concurrent calls, while

Max wireless calls limits the calls made by explicitly specified wireless extensions. IP PBX

service must be reloaded to activate changes.

3.6.2 Reload IP PBX configuration

By clicking Reload button, IP PBX will reload configuration as soon as possible until there is no

active call. Current active calls will be retained up to 3 minutes. This is the most frequently used

function in this page since any IP PBX configuration change has to be reloaded to take effect.

3.6.3 Backup IP PBX configuration

By clicking Backup button, IP PBX archives and encrypts current configuration into a time-

stamped backup file under /tftpboot. To secure configuration files, it is suggested to download

them to a local host through the Get function in Service -> TFTP service once a while. Note

that the filename of a configuration file should not be changed; otherwise, it will be rejected by

the Restore function.

3.6.4 Restore IP PBX configuration

Select a configuration backup file and click Restore button, and IP PBX will restore the

configuration as current setup. One has to choose the Reload function to activate settings.

3.6.5 Restart IP PBX service

Click Restart button, and the IP PBX service will be restarted completely. Currently active calls

will be disconnected immediately. This function should be rarely required unless the LAN

setting has been changed or the service is found operating abnormally without problematic

configuration could be identified.

3.6.6 Revert IP PBX configuration

Click Revert button, and IP PBX will erase current IP PBX settings and revert configuration

back to the factory default. Note the reversion affects IP PBX service only but not rest system

services like DHCP, TFTP, QoS, NTP, STUN, etc. The backup IP PBX configuration files under

TFTP remain intact after reversion, so that one can restore to a specific time if a backup file had

been generated then.

To completely revert the whole system back to the factory default, press the hardware rest button

and hold for 10 seconds before release. Since this will wipe out everything generated by the user,

remember to download configuration files under /tftpboot/ to a local host in case they may be

used later. However, all system interfaces and services must be configured from scratch again.

19 of 49