Graco Reactor 2 H-40 APH046 [20/34] Connect hoses to proportioner

Installation

20 309572ZAT

Connect Hoses to Proportioner

1. Grease with Fusion

grease and connect fluid

hoses to proportioner fluid manifold (M). Red for

hardener (ISO), blue for resin (RES).

NOTE: The manifold hose adapters (N, P) allow use of

1/4 in (6.4 mm). and 3/8 in. (9.5 mm) ID fluid hoses. To

check adapter tightness, torque 1/4 in. and 3/8 in. ID

hoses to:

• A side (N) to 14 ft-lb (19 N•m).

• B side (P) to 20 ft-lb (27 N•m).

To use 1/2 in. (13 mm) ID fluid hoses, remove the

adapters (N, P) from the proportioner fluid manifold and

install them in the FTS or 3/8 in. ID hose inlets. Torque

1/2 in. ID hoses to:

• A side (N) to 43 ft-lb (58 N•m).

• B side (P) to 55 ft-lb (74 N•m).

NOTE: For proportioners with termination box (TB),

follow step 2, For proportioners with electrical splice

connectors (12) follow step 3.

2. Connect hose power wires to terminal block (C) on

termination box (TB). Remove box cover (D) and

loosen lower strain relief (E). Route wires through

strain relief and fully insert into terminal block (A and

B hose wire positions are not important). Torque

terminal connector screws (C) to 26-30 in-lb (2.9-3.3

N•m). Fully tighten strain relief screws and replace

cover.

3. Connect hose power wires to electrical splice

connectors (12) from proportioner or accessory

control box. See Connect Heated Hoses, page 13,

step 5. Connect FTS hose cable (4) to cable from

proportioner or accessory control box. Wrap

connections with electrical tape.

4. Connect FTS cable connectors. Fully tighten RTD

connectors, if provided.

If thermocouple (non-RTD) FTS connectors are

provided, fully tighten connectors and slide

connector covers over the joint.

5. Check that all equipment is properly grounded. See

proportioner manual.