![ADJ Duo Scan RG [2/10] Danger](/img/pdf.png)
ADJ Duo Scan RG [2/10] Danger
![ADJ Duo Scan RG [2/10] Danger](/views2/1990711/page2/bg2.png)
©American DJ® - www.americandj.com - Duo Scan RG Instruction Manual Page 4©American DJ® - www.americandj.com - Duo Scan RG Instruction Manual Page 3
Please carefully read and understand the instructions in this manual
thoroughly before attempting to operate this unit. These instructions
contain important safety information regarding the use and mainte-
nance of this unit. Please keep this manual with the unit, for future
reference.
CAUTION IMPORTANT! When installing this projector, make sure
that it is mounted in a manner that prevents the audience from
looking directly into the beam, and the beam from striking the
audience.
Duo Scan RG General Instructions Duo Scan RG Safety Precautions
Safety Issues: This unit may “pop” the fuse if the maximum allotted
load of 2 amps is reached.
• To reduce the risk of electrical shock or re, do not expose this unit
rain or moisture.
• Do not spill water or other liquids into or on to your unit.
• Do not attempt to remove or break off the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and re in case of an internal short. Do not attempt to oper-
ate this unit if the power cord has been frayed or broken.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no user
serviceable parts inside.
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• Do not attempt to operate this unit, if it becomes damaged.
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties.
• During long periods of non-use, disconnect the unit’s main power.
• Always mount this unit in safe and stable matter.
• Power cords should be routed so they are not likely to be walked
on, pinched by items placed upon or against them.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 18 for cleaning details.
• Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances
(including amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the unit.
C. The unit has been exposed to rain or water.
D. The unit does not appear to operate normally or exhibits a
marked change in performance.
• 10mW Green Laser & 10mW Red Laser (U.S.A.)
30mW Green Laser & 80mW Red Laser (Europe)
• 10 Channel DMX Control
• 3 Operating Modes - Sound Active, Show Mode, & DMX Control
• 20 Laser Patterns
• Digital Display for Address and Function Setting
• UC3 Controller (Not Included)
• Run as Stand Alone unit or in a Master-Slave Conguration
• Power Cord Daisy Chain up to 16 units max. See page 16
Duo Scan RG Features
Duo Scan RG Warranty Registration
The Duo Scan RG carries a 90 day limited warranty. Please fill out the
enclosed warranty card to validate your purchase. All returned service
items whether under warranty or not, must be freight pre-paid and
accompany a return authorization (R.A.) number. If the unit is under
warranty you must provide a copy of your proof of purchase invoice.
Please contact American DJ® customer support for a R.A. number.
DANGER
VISIBLE LASER RADIATION
-AVOID DIRECT EYE EXPOSURE
LASER DIODE
W A VELENGTH : 635~650 nm
Max Output : <4.9mW
Class IIIa Laser Product
!
!
Содержание
- Caution 1
- Customer support 1
- Introduction 1
- To purchase parts online visit http parts americandj com 1
- Unpacking 1
- User instructions 1
- Warning 1
- Danger 2
- Operation instructions and laser safety 3
- Stop and read all laser safety data 3
- Dmx 512 4
- Power supply 4
- Be sure to follow figures two and three when making your own cables do not use the ground lug on the xlr connector do not con nect the cable s shield conductor to the ground lug or allow the shield conductor to come in contact with the xlr s outer casing grounding the shield could cause a short circuit and erratic behavior 5
- Conductor 5 pin xlr male in 3 pin xlr female out 5
- Data compliment signal 5
- Data true signal 5
- Duo scan rg set up 5
- Ground shield 5
- Not used 5
- Notice 5
- Pin 4 do not use 5
- Pin 5 do not use 5
- Pin xlr dmx connectors 5
- Pin xlr to 5 pin xlr conversion 5
- Some manufactures use 5 pin dmx 512 data cables for data transmission in place of 3 pin 5 pin dmx fixtures may be implemented in a 3 pin dmx line when inserting stan dard 5 pin data cables in to a 3 pin line a cable adaptor must be used these adaptors are readily available at most electric stores the chart below details a proper cable conversion 5
- Special note line termination 5
- When longer runs of cable are used you may need to use a terminator on the last unit to avoid erratic behavior a terminator is a 110 120 ohm 1 4 watt resistor which is con nected between pins 2 and 3 of a male xlr connector data and data this unit is inserted in the female xlr connector of the last unit in your daisy chain to terminate the line using a cable terminator adj part number z dmx t will decrease the possibilities of erratic behavior 5
- Dmx address setting 6
- Shnd sh 0 sh 6
- Show modes 0 5 factory programs show mode can run with or without sound active mode on with sound active mode on the shows will tend to run faster 6
- System menu when confirming your setting press enter and then hold menu for at least 2 3 seconds or you can wait 1 minute for automatic setup to exit without making any adjustments press the menu button 6
- This will let you set unit as a master or slave in a master slave configuration 6
- Blackout or stand by mode 7
- Sound active mode 7
- Sound sensitivity control 7
- This function will allow you to test the pan tilt functions 7
- This function will flip the led display 180º 7
- Use this function to reset the unit 7
- With this function you can display the running time of the fixture 7
- With this function you can display the version soft ware of the unit 7
- With this function you can have the led display turn off after 10 seconds 7
- Master slave configuration 8
- Shnd is displayed and press enter 8
- Show mode 8
- Sound active mode 8
- Universal dmx control 8
- Fixture cleaning 9
- American dj europe 10
- American dj supply 10
- American dj world headquarters 10
- Auto sensing voltage 10
- Ew kerkrade 10
- Junostraat 2 10
- Model duo scan rg 10
- Netherlands 10
- Please note 10
- S eastern ave los angeles ca 90040 usa 10
- Service adjgroup eu www americandj eu 10
- Specifications and improvements in the design of this unit and this manual are subject to change without any prior written notice 10
- Tel 31 45 546 85 00 fax 31 45 546 85 99 10
- Tel 323 582 2650 fax 323 582 2610 10
- This fixture contains a automatic volt age switch which will auto sense the voltage when it is plugged into the power source 10
- Web www americandj com e mail info americandj com 10
Похожие устройства
- ADJ Double Phase LED Руководство по эксплуатации
- ADJ Comscan LED System Руководство по эксплуатации
- ADJ BOOM BOX FX3 Руководство по эксплуатации
- ADJ Atmospheric RG LED Руководство по эксплуатации
- ADJ Accu Roller 250 Руководство по эксплуатации
- ADJ Accu Fog1000 DMX Руководство по эксплуатации
- ADJ Quad Phase LED Руководство по эксплуатации
- ADJ Mystic LED Руководство по эксплуатации
- ADJ DiversaRAY Руководство по эксплуатации
- ADJ 46HP LED polish Руководство по эксплуатации
- Sennheiser RS 110-8-II Руководство по эксплуатации
- Yamaha NS-F51 Руководство по эксплуатации
- Sennheiser M2 IEBT SW Руководство по эксплуатации
- Sennheiser M2 IEBT Руководство по эксплуатации
- Sennheiser G4ME ZERO (506064) Руководство по эксплуатации
- Marshall Stockwell Руководство по эксплуатации
- Casio Privia PX-870BK Руководство по эксплуатации
- Casio Privia PX-770WE Руководство по эксплуатации
- Casio Privia PX-770BN Руководство по эксплуатации
- Sennheiser M2 IEG Руководство по эксплуатации