CHAUVET Intimidator Spot 110 [6/18] Ac power

Page 4 of 16

Setup

Intimidator Spot 110 User Manual Rev. 2

3. Setup

AC Power

The Intimidator Spot 110 has an auto-ranging power supply and it can work with an input voltage range of

100 to 240 VAC, 50/60 Hz.

To determine the product’s power requirements (circuit breaker, power outlet, and wiring), use the current

value listed on the label affixed to the product’s back panel, or refer to the product’s specifications chart.

The listed current rating indicates the product’s average current draw under normal conditions.

Fuse Replacement

1. Disconnect the product from power.

2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.

3. Pry the fuse holder out of the housing.

4. Remove the blown fuse from the holder and replace with a fuse of the exact same type and rating.

5. Insert the fuse holder back in place and reconnect power.

• Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure

the product has an appropriate electrical ground to avoid the risk of electrocution or

fire.

• To eliminate unnecessary wear and improve its lifespan, during periods of non-use

completely disconnect the product from power via breaker or by unplugging it.

Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the

rheostat or dimmer channel serves only as a 0 to 100% switch.

Disconnect the product from the power outlet before replacing the fuse.

Safety cap

Spare fuse holder

(inside safety cap)

Installed fuse

(held by plastic clip)