Supermicro SYS-6027R-TRF [12/122] 2 serverboard features

1-2

SUPERSERVER 6027R-TRF USER'S MANUAL

1-2 Serverboard Features

At the heart of the SuperServer 6027R-TRF lies the X9DRi-F, a dual processor

serverboard based on the Intel PCH C602/C606 chipset. Below are the main

features of the X9DRi-F. (See Figure 1-1 for a block diagram of the chipset).

Processors

The X9DRi-F supports single or dual E5-2600 V2 series processors in

Socket R LGA2011 type sockets. Please refer to our web site for a complete listing

of supported processors (www.supermicro.com).

Note: If only one CPU is installed, then only half the PCI-E slots (PCI-E 1~3) will

function in the server. The system needs both CPUs installed for all PCI-E slots

to funtion.

Memory

The X9DRi-F has sixteen (16) single/dual/tri/quad channel 240-pin DIMM sockets

that can support up to 512 GB of DDR3 1866/1600/1333/1066/800 MHz speed

registered ECC SDRAM in two-channel memory bus. Memory sizes of

1GB, 2GB, 4GB, 8GB, 16GB and 32GB @ 1.35V/1.5V voltages are supported.

Please refer to Chapter 5 for installing memory.

Serial ATA

An on-chip (PCH C606) SATA controller is integrated into the X9DRi-F to provide

a six-port, 3 Gb/sec SATA subsystem, which is RAID 0, 1, 5 and 10 supported.

The SATA drives are hot-swappable.

Note: You must have RAID set up to enable the hot-swap capability of the SATA

drives. Documentation on RAID setup guidelines can be found on our web site.

PCI Expansion Slots

The X9DRi-F has three PCI-E 3.0 x8 and three PCI-E 3.0 x16 slots. Note that the

PCI slots are controlled by the CPU so some slots may not be available when two

CPUs are not installed on the board at the same time. See the serverboard layout

in Chapter 5 for details.