Gigabyte GA-770T-D3L (rev. 1.x) [77/100] 1 2 making a sata raid ahci driver diskette

- 77 - Appendix

5-1-2 Making a SATA RAID/AHCI Driver Diskette

(Required for AHCI and RAID Mode)

To successfully install operating system onto SATA hard drive(s) that is/are congured to RAID/AHCI mode,

you need to install the SATA controller driver during the OS installation. Without the driver, the hard drive may

not be recognized during the Windows setup process. First of all, copy the driver for the SATA controller from

the motherboard driver disk to a oppy disk. For installing Windows Vista, you also can copy the SATA con-

troller driver from the motherboard driver disk to a USB ash drive. See the instructions below about how to

copy the driver in MS-DOS and Windows mode.

3: At the A:\> prompt, type the following command. Press <Enter> after the command (Figure 1):

A:\>copy d:\bootdrv\sb7xx\x86\*.*

(Note)

Figure 1

(Note) Type the driver directory based on the operating system to be installed. Refer to the following table

for the SATA driver directories for different Windows operating systems.

Operating System Directory

Windows XP 32-bit Bootdrv\SB7xx\x86

Windows XP 64-bit Bootdrv\SB7xx\x64