Home
Главная
Moser
Стайлеры
CurlProConical
Инструкция по эксплуатации Страница: 9

Moser CurlProConical [9/72] English

ENGLISH

Description of parts (Fig. 1)

A Cool tip

B Conic heating element

C Base stand

D LCD display

E On/off switch

F Button to increase temperature

G Button to reduce temperature

H Handle

I Mains cable with anti-twist device

Operation

· Unfold the base stand and place the appliance on

a flat, smooth, non-heat-sensitive surface.

· Connect to the mains power supply.

· Using the on/off switch (E), switch on the appli-

ance (Fig. 2).

· Set the desired temperature (80°C – 210°C).

The preset temperature is 180°C.

To increase the temperature, press the  button

(F).

To reduce the temperature, press the  button

(G).

Note: The temperature can be adjusted by 5°C

at a time by tapping on either of these buttons. To

adjust the temperature more quickly, hold down

the appropriate button.

· The LCD display flashes three times when the

temperature is set. Once the set operating tem-

perature has been reached, the LCD display

shows the temperature. The LCD display flashes

until the desired temperature has been reached.

After the desired temperature has been reached,

the flashing stops.

· After use, switch off the appliance with the on/off

switch (Fig. 2). Hold the on/off switch to do this.

The LCD display must go out.

· Disconnect from the mains power supply.

· Allow the appliance to cool down.

TITANIUM, CERAMIC and TOURMALINE

(depending on model)

Negative ions have an antistatic effect and are gen-

tle to the hair. They close the scale layer, creating

a smooth, silky hair surface and lock in the natural

moisture of the hair, thereby creating the ultimate

shine.

Tips for successful styling

Important: The appliance comes with a protec-

tive glove - this must be worn (Fig. 4) on the hand

used to wrap the hair around the heating element

in order to protect the fingers. However, the glove

does not protect the fingers if they are exposed to

prolonged contact with the heating element.

· Always test the curling tongs on a small section

of hair first.

· Divide your hair into sections about 2 cm thick

and 4 cm wide.

· Hold the curling tongs vertically. Wind the section

around the conic curling tongs from the base to

the tip to create a spiral. (Fig. 4)

· When the entire section has been wound around

the curling tongs, hold it for a few seconds before

carefully removing the curling tongs from the tight

curl. Do not brush or comb hair while it is warm.

· After curling the desired sections of hair in this

way, the curls can be loosened with the fingers

and the hair can be styled.

Tip: To make it easier to curl hair around the

neck area, hold the curling tongs horizontally

instead of vertically.

· To create large curls, wind the section of hair

around the base (Ø25 mm) of the curling tongs

(Fig. 3) and use the tip (Ø13 mm) of the curling

tongs for smaller curls (Fig. 3).

Cleaning and care

· Before cleaning the appliance, disconnect from

the mains and allow it to cool down.

· Do not immerse the appliance in water.

· Only wipe the appliance with a soft cloth, which

may be dampened slightly. Do not use solvents

or abrasives!

Disposal in EU countries

Do not dispose of the appliance with domes-

tic refuse. As part of the EU Directive

governing the disposal of electrical and elec-

tronic equipment, the appliance is accepted

free of charge by local waste collection

points or recycling centres. Correct disposal

will ensure environmental protection and

prevent any potentially harmful impacts on

people and the environment.

Disposal in non-EU countries

At the end of its service life, please dispose

of the appliance in accordance with statutory

requirements.

Moser CurlProConical [9/72] English

Содержание

Похожие устройства