Kenwood FP510_FP520_FP530 [8/42] Care cleaning

care & cleaning

●

Always switch off and unplug before cleaning.

●

Handle the blades and cutting discs with care - they are extremely sharp.

●

Some foods may discolour the plastic. This is perfectly normal and won’t harm

the plastic or affect the flavour of your food. Rub with a cloth dipped in

Wrap excess cord around the bracket at the back of the appliance.

liquidiser/mill

1 Empty the jug/jar before unscrewing it from the blade unit.

2 Wash the jug/jar by hand.

3 Remove and wash the sealing ring.

4 Don’t touch the sharp blades - brush them clean using hot soapy water, then

rinse thoroughly under the tap. Don’t immerse the blade unit in water.

5 Leave to dry upside down.

twin beater geared whisk

●

●

Wash by hand, then dry.

●

Alternatively they can be washed on the top rack of your dishwasher. A short

low temperature programme is recommended.

service & customer care

●

If the cord is damaged it must, for safety reasons, be replaced by Kenwood or

an authorised Kenwood repairer.

●

If you experience any problems with the operation of the

processor, before calling for assistance refer to the

troubleshooting guide.

we will repair it (or replace it if necessary) free of charge provided:

●

you have not misused, neglected, or damaged it;

●

it has not been modified (unless by Kenwood);

●

it is not second hand;

●

it has not been used commercially;

●

Problem Cause Solution

The processor will not operate. No Power. Check processor is plugged in.

Liquidiser outlet cover not locked on. When using the processor bowl the outlet cover must

be fitted and locked on or the processor will not operate.

Bowl lid not locked on correctly. The processor and liquidiser will not operate if the bowl

lid is not fitted correctly.

Liquidiser not locked on correctly. The liquidiser will not operate if fitted incorrectly.

If none of the above check the fuse/circuit breaker in your

home.

Lid unlocked but speed control light is still on If the lid is unlocked whilst a speed is selected Always turn the speed control to “0” before removing the lid.

Poor performance of tools/attachments Refer to hints in relevant “Using the attachment” section. Check attachments are assembled correctly.