ELEKTRON Digitakt [39/70] Amp page

11. AUDIO TRACK PARAMETERS

11.5.4 REL

Release Time sets the length of the release phase of the ﬁlter envelope. (0–126, INF)

11.5.5 FREQ

Frequency sets the cuto frequency of the multimode ﬁlter. (0.00–127.00)

11.5.6 RESO

Resonance sets the resonance behavior of the ﬁlter. Resonance introduces a peak in the spectrum at

the cuto frequency. (0.00–127.00)

11.5.7 TYPE

Filter Type selects the type of ﬁlter. (OFF, 2-pole Lowpass, 2-pole Highpass)

11.5.8 ENV

Env. Depth sets the amount of cuto frequency modulation from the ﬁlter envelope. The knob is bipolar,

both negative and positive modulation depths are available. Range (64.00–63.00)

TIME

AMPLITUDE

Note On

Attack Decay

Sustain

Note O

Release

11.6 AMP PAGE

The AMP page controls parameters for the amplitude envelope, overdrive, eects sends, panning and

volume.

Press [AMP] to access this parameter page.

11.6.1 ATK

Attack Time sets the length of the attack phase of the amp envelope. (0–127)

11.6.2 HOLD

Hold Time sets the length of the hold phase of the amp envelope. Fixed Hold time values (0–126) specify

the length of the hold phase, and the envelope ignores Note O events such as Trig Length (See “10.6

TRIG PARAMETERS PAGE” on page 31), releasing a [TRIG] key or a key on an external controller.

Setting HOLD to NOTE means the hold phase will be determined by Note On and Note O events.

(0–126, NOTE)

If you set HOLD to NOTE and use an external keyboard to trigger the envelope, then the

sound will be sustained for as long as you press a key on the keyboard (or until the sample

ends).

11.6.3 DEC

Decay Time sets the length of the decay phase of the amp envelope. (0–126, INF)