ADJ Hydro Beam X1 [13/40] Lamp replacement warning

ADJ Products, LLC - www.adj.com - Hydro Beam X1 User Manual Page 12

Hydro Beam X1 Discharge Lamp Warning

LAMP REPLACEMENT WARNING

When the lamp reaches 5700 Hours of usage, the display wll ash the message “Replace LampSoon”. This

message will ash for up to 10 minutes. To conrm this warning and return to normal operation, press

the ENTER button.

When the lamp reaches 6000 Hours of usage, the display wll ash the message “Replace LampNow”.

This message will ash for up to 10 minutes. To conrm this warning and return to normal operation,

press the ENTER button. NOTE: When the xture is powered OFF and then back ON again, the

xture display will ash the following message: “Replace LampNow”.

When the lamp reaches 6200 Hours of usage, the display again wll ash the message “Replace LampNow”.

The unit will now NO longer respond to DMX commands and enter hibernation mode which will

discontinue all xture functionality with the exception of a few menu commands.The xture will

continue to enter into hibernation mode until the lamp is replaced and the lamp time (LAMP ON TIME-R) has

been reset. See page 31 “LAMP ON TIME-R” under the “TOTAL LAMP TIME” submenu.

NOTE: After replacing the lamp, the lamp time MUST be reset. The lamp time must be reset to

gain access to the full system menu.

Lamp Life may vary depending on several factors including but not limited to:

Enviromental Conditions, Power/Voltage, Usage Patterns (On-O Cycling), Control,

and Dimming.