Tp-Link td-w8950n [23/98] Eth interface

TD-W8950N 150Mbps Wireless N ADSL2+ Modem Router User Guide



Note:

The detailed configuration about Scheduler for Queues of Equal Precedence will be described

in Quality of Service

4.4.1.2 ETH Interface

Choose “Advanced Set

up”“Layer2 InterfaceETH Interface”, you can configure ETH WAN

interfaces on the screen below.

Figure 4-4

 Add: Click the Add button, and you can add a new interface in the next screen.

Figure 4-5

 ETH port: Select an ETH port to configure as the WAN port.

Click Save/Apply to save your settings and then you will see the screen similar to Figure 4-6.

Figure 4-6

 Remove: Select the check box in the table on the screen above and then click the Remove

button, the corresponding interface will be deleted in the table.



Note:

Only one ETH is allowed to configure as the layer 2 WAN Interface.

4.4.2 WAN Service

Choose “Advanced Setup”“WAN Service”, and you will see the WAN Port Information Table in

the screen similar to Figure 4-7, which describes the WAN port settings and the relevant

manipulation

to each interface. After you add a new Lay2 Interface, please follow the instructions