Karcher KM 70/30 C Bp Pack Adv [12/165] Faults

Karcher KM 70/30 C Bp Pack Adv [12/165] Faults
- 4
Preparation:
Î Park the sweeper on an even surface.
Î Turn the program selection switch to
"OFF".
Î Loosen 3 fastening screws.
Î Replace side brushes and tighten the
screws.
It is necesary to replace them if the sweep
results are visibly poorer due to wear and
tear of the brushes and it is not possible to
readjust them using "Lever contact pres-
sure of sweep roller".
Î Remove the waste container.
Figure 8, see cover page
Î Pull the lever for contact pressure of
sweep roller fully backwards.
Î Loosen 3 screws each on both the
sides of the sweep roller.
Î Separate the roller halves and remove
them.
Î Place new roller halfs on the sweep roll-
er shaft. Ensure that the pins are sitting
correctly.
Î Fix in the screws and tighten them.
Î Loosen the screws as shown in the re-
spective diagram.
Î Remove the sealing strip and replace it
with a new sealing strip.
Î Fix in the screws and tighten them.
Front sealing strip (at the waste container)
Figure 9, see cover page
Rear sealing strip
Figure 10, see cover page
Side sealing strips
Figure 11, see cover page
Î Pull the handle of the filter shake-off
many times and releaes it.
Î Tilt the dust suction upward.
Figure 12, see cover page
Î Lift out the flat-fold filter and insert a
new flat-fold filter.
Î Remove both the foam filters.
Î Clean the foam filters under flowing wa-
ter and let them dry.
Î Push in the foam filters into the casing.
Ensure that the foam filters are gap-free
on all sides.
Danger
Risk of injury. Before performing any tasks
at the machine, first turn the programme
selection switch to "OFF“and clamp the ca-
ble at the minus pole of the battery.
Maintenance Works
Replacing side brush
Replacing roller brush
Replace the sealing strips
Replace flat fold filter (only Adv. model).
Cleaning the flat-fold filter
Faults
Fault Remedy
Appliance cannot be started Check fuse; replace it, if required *
Check battery; charge it, if needed
Machine is not sweeping properly Check roller brush and side brushes for wear, replace if necessary.
Check the pad for wear, replace if required.
Dust gathers in the machine Empty waste container
Check dust filter - clean or replace it (only Adv. model)
Check the pad for wear, replace if required.
Poor cleaning performance at edges Replace side brush
Check the pad for wear, replace if required.
Inadequate sweep performance (only Adv. model). Check filter case seal
Check washers of the dust suction
Roller brush does not turn. Remove belts or cords from roller brush.
12 EN

Содержание

Похожие устройства

Скачать