Cybex Juno 2-Fix группа 1, Оранжевый, Золотистый (514119017) [14/60] Placing the child seat in the car

Warning! The CYBEX JUNO 2-FIX backrest must lie ﬂ ush with the back of the

car seat. In order to guarantee maximum protection for the child, the seat must

be in a normal, upright position.

Carry out the installation steps in reverse order.

NOTE! It is possible that some car seats that are made of soft material (e.g.

velours, leather, etc.) may show signs of usage and/or discolouration. In order to

avoid this, you could, for example, place a cover or towel underneath it. In this

context, we would also like to refer to you to our cleaning instructions, which

must absolutely be followed before the  rst use of the seat.

NOTE! Retracting the connectors not only protects the car seat, but also protects

the ISOFIX CONNECT system from dirt and damage.

PLACING THE CHILD SEAT IN THE CAR

RELEASING THE ISOFIX CONNECTORS

• Release the ISOFIX connectors (w) on both sides, by pressing and

pulling back the red release buttons (y).

• Pull the seat out of the ISOFIX guides (u).

• Turn the ISOFIX connectors (w) 180°.

• Activate the handle (v) on the underside of the child seat and push the connectors

in until they reach the end position.

• Place the child seat on the appropriate seat in the car.

• To install the seat in an upright position for the child it is essential to take

care that the backrest (a) of the child seat lies flush against backrest of

the car seat.

• You can adjust this distance with the handle (v) on the underside of the child seat.

• If the headrests of the car seats get in the way, pull these completely out, turn

them round, or detach them completely (exception see section „THE BEST

POSITION IN THE CAR“). The backrest (a) adjusts itself in one movement to

almost every position of the car seat.