D-Link DGS-1210-52/ME rev.B [303/519] Q in q commands

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide

285

Q-IN-Q COMMANDS

The Link Aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate

parameters) in the following table.

Command

Parameter

enable qinq

disable qinq

show qinq {ports [<portlist> | inner_tpid]}

config qinq ports

[<portlist> | all] [role [nni | uni] | outer_tpid <hex 0x1 - 0xffff> | add_inner_tag <hex

0x1-0xffff> | missdrop [enable | disable]]

config qinq inner_tpid <hex 0x1-0xffff>

create vlan_translation

ports <portlist> [add | replace] cvid <vidlist> svid <vlanid 1-4094> {priority

<priority 0-7>}

show vlan_translation {cvid <vidlist>}

delete vlan_translation ports [<portlist> | all] {cvid [<vidlist> | all]}

Each command is listed in detail, as follows:

enable qinq

Purpose To enable the Q-in-Q mode.

Syntax

enable qinq

Description

The enable qinq command creates a used to enable the Q-in-Q

mode.

When Q-in-Q is enabled, all network port roles will be NNI port and

their outer TPID will be set to 88a8. All existing static VLANs will run

as SP-VLAN. All dynamically learned L2 address wil

l be cleared.

GVRP and STP need to be disabled manually.

If you need to run GVRP on the Switch, firstly enable GVRP

manually. The default setting of Q-in-Q is disabled.

Parameters None.

Restrictions Only administrator or operator-level users can issue this command.

Example usage:

To enable Q-in-Q:

DGS-1210-28MP/ME:5# enable qinq

Command: enable qinq

Success.

DGS-1210-28MP/ME:5#