D-Link DGS-1210-52/ME rev.B [483/519] Config lldp message_tx_hold_multiplier

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide

465

DGS-1210-28MP/ME:5# config lldp message_tx_interval 10

Command: config lldp message_tx_interval 10

Success.

DGS-1210-28MP/ME:5#

config lldp message_tx_hold_multiplier

Purpose To define the lldp hold-multiplier on the switch.

Syntax

config lldp message_tx_hold_multiplier <int 2-10>

Description

The config lldp message_tx_hold_multiplier command specifies

the amount of time the receiving device should hold a Link Layer

Discovery Protocol (LLDP) packet before discarding it.

Parameters

message_tx_hold_multiplier (int 2-10) – Specifies the hold time to be

sent in the LLDP update packets as a multiple of the timer value.

(Range: 2-10). The default configuration is 4.

Restrictions Only Administrator or operator-level users can issue this command.

Example usage:

To configure LLDP Message tx hold multiplier settings:

DGS-1210-28MP/ME:5# config lldp message_tx_hold_multiplier 2

Command: config lldp message_tx_hold_multiplier 2

Success.

DGS-1210-28MP/ME:5#

config lldp reinit_delay

Purpose To define the lldp reinint–delay on the switch.

Syntax

config lldp reinit_delay <sec 1-10>

Description

The lldp reinit_delay seconds command specifies the minimum

time an LLDP port will wait before reinitializing LLDP transmission.

Parameters

<sec 1-10> – Specifies the minimum time in seconds an LLDP port

will wait before reinitializing LLDP transmission. The range is 1 – 10

seconds. The default configuration is 2 seconds.

Restrictions Only Administrator or operator–level users can issue this command.

Example usage:

To configure LLDP reinit delay: