Ariston AXD 100 [11/88] Before calling read the following

Ariston AXD 100 [11/88] Before calling read the following
Margherita - Iinstructions for installation and use
M
M
ARGHERITA
Before calling, read the following
Troubleshooting
In most cases, when your washing machine fails to work, the problems
arising can be easily solved without having to call for a technician. Before
calling for assistance, always check these points.
The washing machine
fails to start.
Is the plug correctly
inserted into the socket? It
could have been moved whilst
cleaning.
Is there electricity in the
house?
A circuit breaker may have
switched off as a result of too
many electrical appliances
working at the same time. Or
maybe due to a general failure
in your entire area.
Is the washing machine door
closed properly?
For safety reasons, the
washing machine cannot work
if the door is open or not shut
properly.
Is the On/Off button
pressed?
If it is, then a programmed
start has been set.
Is the Start/Reset button
pressed?
If it is, then a programmed
start has been set.
Is the water supply turned
on? For safety reasons, if the
washing machine does not
load water, it cannot start a
wash cycle.
RIGHT
WRONG
Turn off the water
supply after use.
This will eliminate
the possibility of
leakage.
Always leave the
appliance door
ajar to avoid bad
odours.
Clean the
appliances
exteriors gently.
To clean the
exteriors and the
rubber parts of
the appliance,
always use a soft
cloth dipped in
warm and soapy
water.
Leave the washing
machine plugged in
while cleaning.
Even during mainte-
nance, the appliance
should always be
unplugged.
Use solvents and
aggressive abrasives.
Never use solvents or
abrasives to clean the
external and rubber
parts of the washing
machine.
Neglect the detergent
dispenser.
It is removable and
can easily be cleaned
by leaving it under
running water.
Go on holiday without
thinking about her.
Before leaving, always
make sure that the
washing machine is
unplugged and that
the water supply is
turned off.
The washing machine
fails to fill with water.
Is the hose correctly
connected to the tap?
Is there a water shortage ?
There could be work in
progress in your building or
street.
Is there sufficient water
pressure? The autoclave may
be malfunctioning.
Is the tap filter clean? If the
water is very calcareous, or if
work has recently been carried
out on the water piping, the tap
filter could be clogged with
particles and debris.
Is the rubber hose kinked?
The tract of the rubber hose
bringing water to washing
machine must be as straight as
possible. Make sure it is not
squashed or kinked.
The washing machine
continuously fills and
drains water.
Is the drain hose
positioned too low? It must
be installed at a height ranging
from 60 to 100 cm.
Is the end of the hose
immersed in water?
Does the wall drainage
system have a breather
pipe? If the problem persists
even after these checks, turn
the water supply off the
machine and call for
assistance.
If you live on an upper floor of
your building, there may be a
problem with your drain trap.
To solve this problem, a special
valve must be installed.
8
Simple: with the new Ariston technology, you need less than
half of it, to get good results on twice as much!
This is why you cannot see the water through the door:
because there is little, very little of it, to respect the
environment yet without renouncing maximum cleanliness.
And, on top of that, you are also saving electricity.
But where did all the water go?

Содержание

EJ ARGHERITA Troubleshooting Before calling read the following In most cases when your washing machine fails to work the problems arising can be easily solved without having to call for a technician Before calling for assistance always check these points The washing fails to start machine Is the plug correctly inserted into the socket It could have been moved whilst cleaning Is there electricity in the house washing machine cannot woik if the door is open or not shut properly Is the pressed On Off Simple with the new Ariston technology youneedless than half ofit to getgood results on twice asniuch This is why you cannot see the water through the doon because there is little very little of it to respect the environment yet without renouncing maximum cleanliness And on top of that youare also saying electricity button If it is then a programmed start lias been set Is the Start Reset pressed button A circuit breaker may have switched off as a result of too many electrical appliances working at the same time Or maybe due to a general failure in your entire area Is the water supply turned on For safety reasons if the Is the washing machine door closed properly washing machine does not load water it cannot start a wash cycle For safety reasons the But where did all the water go If it is then a programmed start lias been set The washing machine fails to fill with water RIGHT WRONG Turn off the water supply after use This will eliminate the possibility of leakage Always leave the appliance door ajar to avoid bad odours Clean the appliance s exteriors gently To clean the exteriors and the rubber parts of the appliance always use a soft cloth dipped in warm and soapy water Leave the washing machine plugged in while cleaning Even during mainte nance the appliance should always be unplugged Use solvents and aggressive abrasives Never use solvents or abrasives to clean the external and rubber parts of the washing machine Neglect the detergent dispenser It is removable and can easily be cleaned by leaving it under running water Go on holiday without thinking about her Before leaving always make sure that the washing machine is unplugged and that the water supply is turned off Is the hose correctly connected to the tap The washing machine continuously fills and drains water Is there a water shortage There could be work in progress in your building or street Is there sufficient water pressure The autoclave may be malfunctioning Is the tap filter clean If the water is very calcareous or if work lias recently been carried out on the water piping the tap filter could be clogged with particles and debris Is the rubber hose kinked The tract of the rubber hose bringing water to washing machine must be as straight as possible Make sure it is not squashed or kinked Is the drain hose positioned too low It must be installed at a height ranging from 60 to 100 cm Is the end of the hose immersed in water Does the wall drainage system have a breather pipe If the problem persists even after these checks turn the water supply off the machine and call for assistance If you live on an upper floor of your building there may be a problem with your drain trap To soke this problem aspecial valve must be installed Margherita instructions for installation and use 8

Скачать