Home
Главная
Daikin
Чиллер
EWAD650BJYNN/Q
Сервис мануал Страница: 295

Daikin EWAD650BJYNN/Q [295/346] Configuration procedure for the plan settings

Daikin EWAD700BJYNN [295/346] Configuration procedure for the plan settings

ESIE07-04 Procedure for the Changing and Configuration of the Display

Part 3 – Troubleshooting 3–39

6.3 Configuration Procedure for the pLan Settings

This procedure must be done in case a terminal is replaced or added (remote controller) in the pLan

or if settings are changed.

To start configuration, proceed as follows:

Step Action Result

1 Turn on the power supply Nothing will appear on the screen

because no configuration has been made.

Hold down , and simulta-

neously for five seconds.

A screen will appear with the terminal

address and with the address of the board

in examination:

Using the “up” and “down” keys it is possi-

ble to choose the different boards (1 and 2

for pCO² controller and 3, 4, 5 and 6 for

the electronic valve drivers.

3 Select in correspondence with “I/O Board

Addr” the number 1 (Board with address

1) and push “enter”.

In about two seconds the following screen

will appear:

4 Push “enter” again. The following screen will appear:will

appear:

5 If you want to add a second terminal

(remote terminal), change the line “Trm2

None-” with the line “Trm2 8 Sh’

The following screen will be displayed on

the screen:

6 To enable the new configuration put the

pointer on “No” (using the key “enter” and

with “up” and “down” change it to “Yes”

and push enter.

The new configuration is enabled.

Remarks:

P The operations from 1 to 4 must be

repeated for all compressor boards

(“I/O Board” 1 and 2).

P The operations from 1 to 5 must be

repeated for all compressor boards

(“I/O Board” 1 and 2) if remote terminal

is connected.

enter

Terminal Addr: 7

I/O Board Addr: n

Press ENTER

To continue

Terminal Config

P: 01

Tr m2

Tr m1

Tr m3

Addr

None

Priv/Shared

---

---Ok? No