Panasonic WH-MDF12C9E8 Сервис мануал онлайн
© Panasonic HA Air-Conditioning (M) Sdn. Bhd. 2010.
Unauthorized copying and distribution is a violation of law.
Order No. PHAAM1010087C2
Monobloc Air-to-Water Heatpump System
Monobloc Unit
WH-MDF09C3E8
WH-MDF12C9E8
WH-MDF14C9E8
WH-MDF16C9E8
PRECAUTION OF LOW TEMPERATURE
In order to avoid frostbite, be assured of no refrigerant leakage during the installation or repairing of refrigerant circuit.
WARNING
This service information is designed for experienced repair technicians only and is not designed for use by the general public.
It does not contain warnings or cautions to advise non-technical individuals of potential dangers in attempting to service a product.
Products powered by electricity should be serviced or repaired only by experienced professional technicians. Any attempt to
service or repair the product or products dealt with in this service information by anyone else could result in serious injury or death.
Содержание
- Monobloc air to water heatpump system 1
- Monobloc unit 1
- Wh mdf09c3e8 wh mdf12c9e8 wh mdf14c9e8 wh mdf16c9e8 1
- Table of contents 2
- Carry out test run to confirm that no abnormality occurs after the servicing then explain to user the operation care and maintenance as stated in instructions please remind the customer to keep the operating instructions for future reference 3
- Read the following safety precautions carefully before perform any servicing electrical work and water installation work must be installed or serviced by a licensed electrician and licensed water system installer respectively be sure to use the correct rating and main circuit for the model installed the caution items stated here must be followed because these important contents are related to safety the meaning of each indication used is as below incorrect installation or servicing due to ignoring of the instruction will cause harm or damage and the seriousness is classified by the following indications 3
- Safety precautions 3
- The items to be followed are classified by the symbols 3
- Specifications 5
- Wh mdf09c3e8 5
- Note heating capacities are based on outdoor air temperature of 7 c dry bulb 44 f dry bulb 6 c wet bulb 42 f wet bulb with controlled indoor water inlet temperature of 30 c and water outlet temperature of 35 c specification are subjected to change without prior notice for further improvement 6
- Wh mdf12c9e8 7
- Note heating capacities are based on outdoor air temperature of 7 c dry bulb 44 f dry bulb 6 c wet bulb 42 f wet bulb with controlled water inlet temperature of 30 c and water outlet temperature of 35 c specification are subjected to change without prior notice for further improvement 8
- Wh mdf14c9e8 9
- Note heating capacities are based on outdoor air temperature of 7 c dry bulb 44 f dry bulb 6 c wet bulb 42 f wet bulb with controlled indoor water inlet temperature of 30 c and water outlet temperature of 35 c specification are subjected to change without prior notice for further improvement 10
- Wh mdf16c9e8 11
- Note heating capacities are based on outdoor air temperature of 7 c dry bulb 44 f dry bulb 6 c wet bulb 42 f wet bulb with controlled water inlet temperature of 30 c and water outlet temperature of 35 c specification are subjected to change without prior notice for further improvement 12
- Features 13
- Location of controls and components 14
- Monobloc unit 14
- Main components 15
- Location of control 16
- Remote control 16
- Weekly timer setting 19
- Setting up the special functions 20
- Dimensions 21
- Monobloc unit 21
- Refrigeration and water cycle diagram 22
- Block diagram 24
- Wh mdf09c3e8 24
- Wh mdf12c9e8 wh mdf14c9e8 wh mdf16c9e8 25
- Wh mdf09c3e8 26
- Wiring connection diagram 26
- Wh mdf12c9e8 wh mdf14c9e8 wh mdf16c9e8 28
- Electronic circuit diagram 30
- Wh mdf09c3e8 30
- Wh mdf12c9e8 wh mdf14c9e8 wh mdf16c9e8 32
- Main printed circuit board 34
- Printed circuit board 34
- Water system 34
- Solar printed circuit board optional 35
- Main printed circuit board 36
- Refrigerant system 36
- Noise filter printed circuit board 37
- Installation instruction 38
- Monobloc unit 38
- Monobloc unit installation 40
- Select the best location 40
- Piping installation 41
- Connect the cord and cable to monobloc unit 42
- Connecting requirement 43
- Wire stripping and connecting requirement 43
- Allow sufficient space around the remote controller 1 as shown in the illustration above 44
- Avoid installing the remote controller cable near refrigerant pipes or drain pipes else it will cause electrical shock or fire 44
- Install in a flat surface to avoid warping of the remote controller if installed to a wall with an uneven surface damage to the lcd case or operation problems may result 44
- Install in a place where the lcd can be easily seen for operation standard height from the floor is 1 to 1 meters 44
- Install in a place which is away from direct sunlight and high humidity 44
- Selecting the installation location 44
- Wired remote controller installation 44
- Installing the remote controller unit to the wall 45
- Route the remote controller cable 2 inside the lower 45
- Connecting the remote controller cable to monobloc unit 46
- Disposal of monobloc unit drain water 46
- Basic function 47
- Heating operation 47
- Internal water setting temperature 47
- Operation and control 47
- Tank mode operation 47
- Thermostat control 47
- Heat tank mode operation 49
- Heating mode operation time chart 52
- Setting water outlet temperature for heat mode 52
- Water temperature thermo shift setting 52
- Fan motor operation 53
- Flow switch 54
- Flow switch control 54
- Pump down operation 54
- Water pump 54
- Water pump control 54
- Auto restart control 55
- Force heater mode operation 55
- Monobloc unit safety 55
- Monobloc unit safety control 55
- Back up heater control 56
- Electric heater control 56
- Indication panel 56
- Quiet operation 57
- Sterillization mode 57
- Tank booster heater control 57
- Three way valve control 57
- Solar operation 58
- Solar operation control 58
- Solar operation optional 58
- Connection external room thermostat wire connection and thermo characteristic of siemen rev200 61
- Control content external room thermostat control activate only when remote thermostat connection select yes by indoor remote control when indoor running heat mode refer thermo on off from heating line feedback and when indoor running cool mode refer thermo on off from cooling line feedback heatpump off immediately when receive thermo off feedback 61
- External room thermostat control optional 61
- Purpose 1 better room temperature control to fulfill different temperature request by external room thermostat recommended external room thermostat 61
- Wire connection and thermo characteristic of siemen raa20 61
- 30 seconds forced operation 62
- Compressor overheating prevention control 62
- Ipm power transistor prevention control 62
- Protection control 62
- Protection control for all operations 62
- Time delay safety control 62
- Total running current control 62
- 0 crank case heater control 63
- Deice operation 63
- High pressure sensor control 63
- Low frequency protection control 1 63
- Low frequency protection control 2 63
- Outdoor air temperature control 63
- Outside temperature current control 63
- Protection control for heating operation 63
- Expansion vessel pre pressure checking 64
- How to adjust water flow rate 64
- Proper pump down procedure 64
- Servicing mode 64
- Test run 64
- Maintenance guide 65
- Refrigeration cycle system 67
- Troubleshooting guide 67
- Carry out the measurements of pressure electric current and temperature fifteen minutes after an operation is started 68
- Relationship between the condition of the monobloc unit and pressure and electric current 68
- Breakdown self diagnosis function 69
- Self diagnosis function three digits alphanumeric code 69
- Error codes table 70
- Connection capability rank abnormality h12 72
- Self diagnosis method 72
- Compressor tank temperature sensor abnormality h15 73
- Indoor refrigerant liquid temperature sensor abnormality h23 74
- Compressor low pressure protection h42 75
- Water flow switch abnormality h62 76
- Outdoor high pressure abnormality h64 77
- Indoor backup heater olp abnormality h70 78
- Tank temperature sensor abnormality h72 79
- Indoor control panel communication abnormality h76 80
- 0 indoor outdoor abnormal communication h90 81
- 1 tank booster heater olp abnormality h91 82
- 2 unspecified voltage between indoor and outdoor h95 83
- 3 outdoor high pressure protection h98 84
- 4 indoor freeze up protection h99 85
- 5 outdoor high pressure switch activate f12 86
- 6 compressor rotation failure f14 87
- 7 outdoor fan motor dc motor mechanism locked f15 88
- 8 input over current detection f16 89
- 9 compressor overheating f20 90
- 0 ipm overheating f22 91
- 1 output over current detection f23 92
- 2 refrigeration cycle abnormality f24 93
- 3 four way valve abnormality f25 94
- 4 outdoor high pressure switch abnormal f27 95
- 5 outdoor air temperature sensor abnormality f36 96
- 6 indoor water inlet temperature sensor abnormality f37 97
- 7 outdoor discharge pipe temperature sensor abnormality f40 98
- 8 power factor correction pfc abnormality f41 99
- 9 outdoor pipe temperature sensor abnormality f42 100
- 0 outdoor defrost temperature sensor abnormality f43 101
- 1 indoor water outlet temperature sensor abnormality f45 102
- 2 outdoor current transformer open circuit f46 103
- 3 cooling high pressure overload protection f95 104
- Disassembly and assembly instructions 105
- To remove the cabinet front plate 105
- To remove the cabinet top plate 105
- To remove pressure gauge 106
- To remove rccb 106
- To remove the cabinet rear plate 106
- To remove pressure relief valve 107
- To remove transformer and electronic controller board 107
- To remove bottle complete 108
- To remove flow switch 108
- To remove water pump 108
- Operation characteristics 109
- Technical data 109
- Wh mdf09c3e8 109
- Wh mdf12c9e8 111
- Wh mdf14c9e8 113
- Wh mdf16c9e8 115
- Heating capacity table 117
- Hydraulic pump performance 117
- Wh mdf09c3e8 117
- Wh mdf12c9e8 117
- Wh mdf14c9e8 117
- Wh mdf16c9e8 117
- Exploded view and replacement parts list 118
- Wh mdf09c3e5 wh mdf12c6e5 wh mdf14c6e5 wh mdf16c6e5 refrigerant system 118
- Note all parts are supplied from phaam malaysia vendor code 00029488 o marked parts are recommended to be kept in stock 122
- Wh mdf09c3e5 wh mdf12c6e5 wh mdf14c6e5 wh mdf16c6e5 water system 123
- Note all parts are supplied from phaam malaysia vendor code 00029488 o marked parts are recommended to be kept in stock 125
- Phaam printed in malaysia sybz1010 00 125
Похожие устройства
- Panasonic WH-MDF14C9E8 Сервис мануал
- Panasonic WH-MDF16C9E8 Сервис мануал
- Panasonic CS-XE9CKE Сервис мануал
- Panasonic CS-XE12CKE Сервис мануал
- Panasonic CU-XE9CKE Сервис мануал
- Panasonic CU-XE12CKE Сервис мануал
- Panasonic CU-A18BKP5 Сервис мануал
- Panasonic CU-A24BKP5 Сервис мануал
- Panasonic CS-A18BKP Сервис мануал
- Panasonic CS-A24BKP Сервис мануал
- Panasonic CS-A18BKP / CU-A18BKP5 Сервис мануал
- Panasonic CS-A24BKP / CU-A24BKP5 Сервис мануал
- Аксион ТВ12 Руководство по эксплуатации
- Panasonic CS-F24DB4E5 Сервис мануал
- Panasonic CS-F28DB4E5 Сервис мануал
- Panasonic CS-XE9DKE Сервис мануал
- Panasonic CU-XE9DKE Сервис мануал
- Panasonic CS-XE12DKE Сервис мануал
- Panasonic CU-XE12DKE Сервис мануал
- Panasonic CS-C9BKPG Сервис мануал