PRESONUS S1 Artist 3.0 [247/307] Studio one reference manual

Sync Click to engage LFO tempo sync. Time is expressed as Beats.

Speed Variable from 0.01 Hz to 10 Hz.

Beats Select from 4/1 to 1/64 with triplet and dotted-time variants.

Depth Adjusts the wet/dry mix of the Flanger output.

Feedback Adjusts the amount of delayed output to be fed back into the input. Variable from -90% to 90%. Neg-

ative value results in inverted feedback.

Delay Adjusts the delay time for the copied input signal. Variable from 0.25 ms to 10 ms.

Depth Adjusts the mix of the processed Flanger output with the original dry input signal. Variable from 0 to 100%.

Phaser

Phaser applies a variable number of allpass filters in series (one fed into the other), along with one overall feedback loop,

to the input signal. Phaser features an LFO to modulate the center frequencies for each all-pass filter.

The allpass filters function as frequency-dependent delays, so that when the filtered output is added to the original input

signal, certain frequencies can be attenuated or amplified as the result of phase shifting. Phasers are commonly used on

many types of signals, including synths, guitars, and even vocals, to create a distinctive frequency-shifting effect.

The following parameters are available for Phaser:

LFO Modulates the center frequency for the allpass filters between the range set by Range Low and Range

High.

Range Low Adjusts the lowest center frequency for the allpass filters. Variable from 10 Hz to either 8

kHz or the Range High value.

Range High Adjusts the highest center frequency for the allpass filters. Variable from either 10 Hz or

the Range Low value to 8 kHz.

Speed/Beats Adjusts the speed of the LFO.

Sync Click to engage LFO tempo sync. Time is expressed as Beats.

Speed Variable from 0.01 Hz to 10 Hz.

Beats Select from 4/1 to 1/64, with triplet and dotted-time variants.

Feedback Adjusts the amount of the filtered output signal to be fed back into the input. Variable from 0 to 95%.

Stages Adjusts the number of allpass filter stages in the Phaser. Variable from 2 to 20.

Spread Adjusts the spread of each allpass filter from 0 to 100%

Depth Adjusts the mix of the processed Phaser output with the original dry input signal. Variable from 0 to 100%.

240│Studio One Reference Manual