MOTU Micro Lite Руководство по эксплуатации онлайн [85/166] 776062

CLOCKWORKS FOR MAC OS 9

Turning off Frame lock can be a life saver if you ﬁnd

yourself in a situation where you have time code on tape

(or other source) but the frame locations jump around to

different times (because of overlapping SMPTE striping,

edits, or whatever). By turning off Frame lock, you can

sync continuously to this type of time code without

glitching or stopping. If the SMPTE on your tape jumps

around as described, you are likely to experience brief

drop-outs at the points where it jumps. If so, just increase

your MOTU interface’s freewheeling to cruise past them.

Enable still-frame sensitivity

This option lets you control how many frames in a row

your MOTU interface needs to receive to consider

incoming SMPTE as being parked on a single frame.

While lowering this value makes your MOTU interface

more responsive when you pause your video deck, it is also

more likely to misinterpret ordinary transport shuttling.

So make this value as low as you can, but raise it if you start

getting improper frame locations when shuttling your

deck.

Generate signal when stopped

This option applies to situations in which your MOTU

interface is converting time code and the source time code

continues even when it is parked on a frame. The most

common case is when your MOTU interface is locked to

VITC, and the video deck is paused. In this situation, the

Generate signal when stopped option, when checked,

makes your MOTU interface continues to output time

code (LTC, MTC and VITC), even while the video is

parked on a single frame in pause mode. It will continue to

do so as long as the video head is engaged and VITC lines

can be scanned.

Auto-detect input frame rate

When this option is checked, your MOTU interface will

automatically detect the frame rate of incoming SMPTE

time code (VITC, LTC or MTC). In most situations, this is

desirable because it ensures that your MOTU interface is

properly interpreting and synchronizing to the time code.

If, however, you ﬁnd yourself in a situation where you

would like to set the frame rate manually, uncheck this