Kurzweil FORTE [98/244] Output

Program Edit Mode

Program Pages

7-9

Output

e Output parameter species the rear panel analog output pair to which the selected aux

bus is routed. Setting the Output to A routes the signal of the selected bus to output pair A.

Setting the Output to B routes the signal of the selected bus to output pair B. is is useful

if you want to control the processed Aux signal with an external mixer or process the signal

with additional external eects.

Auxiliary Send Parameters

e Auxiliary Send parameters determine the level of the program signal sent to the auxiliary

eects chain.

Aux Send

e Aux 1 send works as a dry/wet mix, so that as you turn up the Aux 1 send,

the program’s unprocessed signal is turned down. With an Aux 1 send set to 50%

you hear an equal amount of processed and unprocessed signal (called wet and dry,

respectively.) With an Aux send set to 100% you hear only the processed (wet) signal

and none of the original unprocessed (dry) signal.

For most programs, the Aux 2 send works the same way as the Aux 1 send, and

send level is set in percent. For some programs (mostly piano programs), the Aux

2 send level is set in dB and works more like a traditional send on an audio mixing

board. e level of signal sent to the Chain is set in dB, the higher the value the

more processed signal you will hear. When the Aux 2 send level is set in dB, the

unprocessed signal does not get turned down as the Aux 2 send is turned up.

Pre/Post Ins

e Pre/Post Insert parameter determines the point at which the auxiliary eect is

applied to the signal.

When this parameter is set to Post, the Forte applies the auxiliary eect to the signal

post insert, i.e., after the insert eect has been applied.

When this parameter is set to Pre, the Forte applies the auxiliary eect to the signal

pre insert.

To hear a program put through two eects Chains in series (i.e., route the processed

Insert signal through the Aux 1 Chain), choose your desired eects Chains for the

Insert and Aux 1, set each bus Output to Main, and set the Aux 1 Send parameter to

100%. en, set the Pre/Post Insert parameter to Post.

To hear a program put through two eects Chains in parallel (i.e., don’t route the

processed Insert signal through the Aux 1 Chain), choose your desired eects Chain

for the Insert and either Aux, set each bus Output to Main, and set the Aux Send

parameter to either 50% or 0 dB. en, set the Pre/Post Insert parameter to Pre for

the desired aux.