Ака Berkut-5 VERSION 5.01 [29/43] Dynamic and static operating modes

More in detail about adjustment of gauges it is described in section the Built in

program of adjustment of gauges on p. 38.

DYNAMIC AND STATIC OPERATING MODES

Dynamic mode is the main mode of operation of the detector. It is characterized in

that the processor constantly adjusts to relatively slow changes in ground conditions.

Therefore, in this mode, the instrument responds to the desired objects only when moving the

coil. If the coil is stationary over an object after a while the sound will disappear. This is the

primary mode your detector is in every time you turn it on. The speed of auto fine tuning of

the ground is based upon the AGB parameter, the level of soil mineralization, the

heterogeneity of the soil mineralization and the sweep speed of the coil. (see

Parameter "AUTOFINE TUNING" on p. 18).

Pressing the button [ ], enters the pinpoint mode in which auto fine tuning is

disconnected. The lcd display will now display the pinpoint mode screen (a Fig. 30).

TURBO

WITH

Fig. 30

Prior to initiating the pinpoint mode it is necessary to locate the approximate

position of the target. Then move the coil off to one side and press the [ ]. Pressing the

button should occur in a location where there or no metal objects under or near the edge opf

the coil. Once the pinpoint mode is enabled it is important to keep the coil at a constant

search height and parallel to the the ground and to avoid lfiting or lowering of the coil

while pinpointing.

To disable the pinpoint mode press the [ ] button. If the parameter Pinpoint

Automatic has been enabled then the pinpoint mode will be disabled and returned to the

normal search mode after the selected amount of time.

To adjust for optimum operation of the pinpoint mode see section Pinpoint Gain

(page 30).

31 32