Ака Berkut-5 VERSION 5.01 [33/43] Overload mode

To quickly set the special signal to a certain class of objects you may use the fast

teach mode. Insure that teach mode is set to on. Insure device is in discriminate mode (D).

Scan the desired target insuring an accurate and repeatable VDI.

To include the scanned target in the special signal press the button. To cancel

the operation press [PR/MENU] .

Any object whose VDI falls within this sector will generate the bell tone.

OVERLOAD MODE

AT times you will encounter large shallow objects that can overload the detectors

electronics. Under this overload condition the detector cannot properly identify the object.

When this happens a warning message will be displayed and an audible warning will be

heard. The volume of which is set under parameter OVERLOAD VOLUME (page 23).

S K M An TURBO

OVERLOAD

Fig. 33

If the overload warning occurs too often

it is recommended to reduce the

sensitivity of the device by means of parameters gain and/or coil current (p. 17, 18) or to lift

the gauge above over a ground. If the overload arises on single instances simply raise the

coil and re scan the object.

There can be situations where an overload occurs yet no target can be located.

This is usually due to an elevated level of mineralization in the ground

. In this case

it is

necessary to reduce sensitivity.

USER PROGRAMS

The detector has been programmed with 4 user programs. These programs are fully

able to be edited by the user to suit their own preferences. Switching between programs is

carried out by short term pressing of the [PR/MENU] button. In the bottom left hand

corner of the display is the number of the currently selected program.

Any change of a parameter is automatically stored in memory for the current

program. Remember the detector can be restored to the default factory settings at any

time. To perform the factory resets turn the detector off. Press and hold the [PR/MENU]

button while turning the detector on. Once the detector has turned on a message will be

displayed indicating factory settings have been restored. The Menu button can now be