Ака Berkut-5 VERSION 5.01 [34/43] Replacing the search coil

released and the unit will enter the standard search mode. The current program

will be program №1. And the ground balance reference point will be(0).

ATTENTION! The parameters for the coils are not reset and will be retained during a

factory reset

The factory program №1-This program has the sensitivity set low which gives it

stable response to the ground and economic battery life (low coil current). It is intended

when searching for large or shallow objects. The discriminator is set to reject most

undesirable targets. The included filters suppress most of the unwanted signals.

The factory program №2- This program has sensitivity set a bit higher than Prog.

1. Again this program is most useful in detecting medium to large targets and those targets

at shallow to medium depths as well as detecting in areas littered with trash.

The factory program №3- This program has higher sensitivity levels and

intended for searching smaller objects that are deeper.

In most cases it provides very

good depth while retaining a good quality of search. The coil current is set to TURBO

therefore power consumption is higher than in the first two programs.

The factory program №4- This program has high levels of sensitivity and is

intended to search for deeply buried targets in areas with minimal levels of trash. In this

program it is important to slow the sweep speed and maintain a constant distance from the

ground without deviations. Also in this program the coil current is set to TURBO.

In program №1 the discriminator is for maximum rejection of unwanted targets.

Targets typically rejected include small ferrous objects, small pieces of foil and

aluminum wire. Typical targets that are accepted would be objects made from copper, silver

larger pieces of aluminum as well as other similar objects. This program may reject targets

that are desirable to you such as small gold or jewelry as well as some small hammered

coins.

In program 2-4 The discriminator is set to reject small ferrous targets.

Remember that these programs are intended as a starting point to allow the user to become

acquainted with the device. For maximum efficiency of the detector the user will need to

adapt the programs to their search conditions.

Remember when adjusting any of the programs to try and have an understanding of

what the parameter is and how it will affect the detector in the field. Just because an

increased setting will result in improved air tests does not mean this will necessarily happen

under actual detecting conditions.

RECOMMENDATION! At first power up factory programs will be installed.

REPLACING THE SEARCH COIL

If your detector is supplied with two or more search coils, configured to work

with your device, in order to replace them perform the following.

1. Turn off the detector.

36 37