Ака Berkut-5 VERSION 5.01 [37/43] Addition of a new coil to a new profile

ADJUSTING THE NEW COIL TO THE

CURRENT PROFILE

If, while in use, it was necessary to make repeated adjustments to the coil, or you

do not wish to use different profiles for different coils, and prefer to make adjustment at

each switching of gauges (similar to some of our other models), take advantage of a mode

of adjustment of the new coil under the current profile. This mode can be activated in

several ways:

By means of the basic menu of the device (Coils - Editor - Auto)

By means of the inclusion menu (Power on while depressing [Fn] -

To adjust the coil)

By means of fast accessing the main menu (Powering on while holding button [+])

For adjusting the new coil for the current profile:

Turn off the detector

Connect the coil to the device

Activate one of the modes described above

After the automatic adjustment of the frequency and ORT, the device switches to

Ground Balance

Perform the Ground Balance procedure on pure ground, ferrite or a piece of red

brick.

If the GB value differs from zero significantly then press the button [ ] to zero.

To exit from the adjustment mode press the button [GB]

Switch the device off and then back on.

Recheck the operation of the detector on several typically found objects.

ADDITION OF A NEW COIL TO A NEW PROFILE

If you have purchased a new coil whose size or operating frequency is different

from a previously established coil then it is necessary to use the mode addition of the new

coil. It can be performed in two ways:

By means of the basic menu of the detector (Coils - Editor)

By means of the inclusion menu (Power on while depressing the button [Fn]-

To add the gauge)

For addition of the new gauge to a new profile, it is necessary to perform the

following:

Turn off the detector

Connect the coil to the device

Activate a mode one of specified above ways

Choose the profile name, corresponding to the parameters of the new coils

(size and frequency)

Activate an adjustment mode

 If you are using the main menu method then move the cursor to AUTO and

press [+]

