Ака Berkut-5 VERSION 5.01 [38/43] Some councils about operation





If you are using the inclusion menu then after choosing the corresponding

profile press [+]

After automatic adjustment of the frequency and ORT, the device will switch to the

Ground Balance mode.

Perform the Ground Balance procedure on pure ground, ferrite or a piece of red brick.

If the GB value differs from zero significantly then press the button [ ] to zero.

To exit from the adjustment mode press the button [GB]

Switch the device off and then back on.

Recheck the operation of the detector on several typically found objects.

STORINGYOUR METAL DETECTOR

Your metal detector is a complex electronic device that is constantly exposed to a

harsh environment in the field. To insure a long service life it is important to monitor its

performance and condition and to store it properly.

Store your detector in a warm dry place. If the device is to be stored for long

periods of time, longer than 2 weeks, it is required to remove the batteries. Over a long

period of storage batteries can leak and damage your device.

After each use it is recommended to clean the detector including the coil, rods

and control box from dirt. Immediately after use it is recommended to remove the

batteries. If the detector has been used in particularly damp environments, rain or

extremely humid weather, then remove the batteries from the device. Leave the battery

cover off of the detector and allow the internal area of the detector to dry out preferably

in a warm and dry room to prevent moisture from condensing on the electronics.

Moisture can evaporate through the slots in the control box so it is best to store in an

upright position.

Do not attempt to help the detector dry out by using ANY external heat device

such as a hair dryer, torch or any open flame as damage will occur to the control box or

coil.

Should water ever enter the control box immediately remove the batteries leaving

the cover off and contact the service department.

SOME COUNCILS ABOUT OPERATION

МЕТАЛЛОДЕТЕКТОРА

This section intentionally left blank due to problems properly translating the

original authors’ intents and explanations.