Moxa ioLogik W5312-T [96/194] More information about repeat interval vs edge detection

ioLogik W5300 Click&Go Logic

4-24

System Start-up

Click&Go logic provides the IF condition to perform an action, such as triggering the local output or SMS alarm

to indicate that the system is restarting.

More Information about Repeat Interval vs. Edge Detection

Combining the Timer function with other IF conditions allows actions to be repeated when the specified logic is

sustained over a period of time. However, if a condition is based on edge detection (i.e., ON to OFF or OFF to

ON), it can only be triggered once.

The following scenarios illustrate how edge detection affects the Timer = N sec. In each diagram, the statuses

of three sensors are shown over a period of time, with a high signal corresponding to a “true” condition. The

green shaded area shows the duration of time that the IF conditions have been met.

No Edge Detection

In this scenario, the rule checks each sensor for “on” status, so edge detection is not involved. As long as the

sensors remain on, the required conditions are satisfied, and the THEN actions will repeat at interval N.

DI-0 = ON

DI-1 = ON

DI-2 = ON

Relation between

conditions

AND OR

“IF” conditions

satisfied

Repeat interval “Timer = N sec” “Timer = N sec”

“THEN” action

triggered