IKA RCT basic 0003810000 [19/140] Intended use assembling the stand

IKA RCT basic 0003810000 [19/140] Intended use assembling the stand
19
Unpacking
/// Unpacking
Please unpack the device carefully
In the case of any damage a detailed report must be sent
immediately (post, rail or forwarder)
/// Scope of delivery
Heating magnetic stirrer
Mains cable
Operating instructions
• Screwdriver
Protective cover
Temperature sensor PT 1000
/// Use
The magnetic stirrer is suitable for mixing and / or heating subs-
tances.
/// Area of use
Indoor environments similar to that a laboratory of research,
teaching, trade or industry area.
The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not supplied
or recommended by the manufacturer,
- if the device is operated improperly or contrary to the
manufacture’s specifications,
- if the device or the printed circuit board are modified by third
parties.
Intended use
Assembling the stand
Note: When using bath attachments
with a diameter over 180 mm, please
use support rod in conjunction with an
extension. (See “Accessories”)
Remove screw plugs (M).
Remove the protective cap from the support rod.
Put the washer between housing and nut.
Screw the support rod onto the device
by hand until the end stop is reached.
Use an A/f 17 spanner to tighten the
M10 nut.
Accessories should be attached using
cross sleeves.
Risk of tipping!
Make sure that the center of mass of the
attached device does not protrude over
the safe area indicated with a dashed
rectangle.
safe area

Содержание

Скачать