Grillo GH 9 Инструкция по эксплуатации онлайн [17/71] 520666

Translation of the Original Instructions

with other implements. The cutting bar is attached to the all purpose flail implement frame instead

of the all purpose flail.

Maintenance: grease the cross pins every 8 working hours through the grease nipples on the

swinging crank. Grease the cutting bar swinging bushing every 50 working hours through the

grease nipple under the swinging protection.

Keep the blade ledger plates properly adjusted. They must be neither too tight, so that they block

the blade, nor too loose so that there is too much clearance between them and the blades. To

remove the blade take off the L-shaped blade coupling by loosing the two screws and slip off the

blade. Take care to tighten the fixing screws of the coupling after assembling the blade again.

Always use sharp blades: the machine will be subject to less strain and its working life will be

longer. Clean the cutting bar after every working day, removing any remaining pieces of grass or

earth; frequently that all screws are tight.

ORIENTABLE AND TILTING SWEEPER – 80 cm

This sweeper (fig. 23) is very useful to clean roads and squares. It can also be used to clean up

10-12 cm high fresh snow and it can be steered left or right to make drifts. It is mounted following

the same procedure as for the cutting bar.