Partner PSKL72B [8/40] England

MAINTENANCE (starts at page 36)

ENGLAND

Caution! Switch off the engine and disconnect the spark plug before undertaking any

maintenance work.

MOWING BAR (starts at page 36)

ADJUSTMENT OF CUTTING HEIGHT

This adjustment must be carried out when the engine is not running. For this purpose disengage the two skids from the blade-holder (16), loosen screws (17), and then

with the machine assembled, In this case the blade must be disengaged.For

checking move the blade by hand make sure that the wear-plates are not

excessively tightened.

To adjust the wear plates (T), individually. Turn screw (U) slightly. At each

adjustment of a wear-plate, the blade should be moved by hand for checking

that it can be moved without effort. The correct adjustment is obtained when

there is only the minimum possible distance between blade and counterblade

(0.2 mm).

SHARPENING has to be carried out when the mower blade does not cut perfectly. For

this purpose, the blade must be sharpened bu an authrosied dealer.

products.

Working: if after pressing the control handle (4) the machine will not start, adjust

the control cable (18), inserting the tie rod (19) in one of the following holes (20) of

the plate (21)

Moving on: if the machine will not proceed or remain in work, adjust the screw (22)

situated on the wheels control lever(2).

Replacement of the driving belt: release the tie rod (19) from the control handle

(4), take off the protection guard (5), remove the belt (23).Replace the new belt and

reassamble as before.

Reduction gear (13): contains oil SAE 20/40, W140 about 0,5 kg.