Ski-Doo Ski Doo SUMMIT 2005 [1110/1429] Piston rings

Ski-Doo Ski Doo MX Z 2005 [1110/1429] Piston rings
Section 04 ENGINE (4-TEC)
Subsection 06 (CRANKSHAFT/DRIVE GEARS)
NOTE: Replaceconnectingrodifdiameterofcon-
necting rod small end is out of specifications.
Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
NOTE: Applyengineoilonthepistonpin.
Insert piston pin into piston and connecting rod.
CAUTION: Take care that piston will be installed
with the punched arrow on piston top to the
exhaust side.
1
R1004motr30A
1. Arrow should indicate to the exhaust side
Use the piston circlip installer (P/N 529 035 765)
to assemble the piston circlip.
CAUTION: Secure piston pin with new piston
circlips.
NOTE: Take care that the hook of the piston circlip
is positioned properly.
1
R1004motr31A
2
1. Sleeve with piston circlip inside
2. Assembly jig from piston clip installer
PISTON RINGS
Removal
Remove:
cylinder head (refer to CYLINDER AND CYLIN-
DER HEAD)
cylinder (refer to CYLINDER AND CYLINDER
HEAD)
piston pin no. 12 (refer to PISTON above)
piston no. 10.
Inspection
Ring/Piston Groove Clearance
NOTE: Using a feeler gauge measure each
ring/piston groove clearance. If the clearance is
too large, the piston and the piston rings should
be replaced.
244 mmr2005-026

Содержание