Ski-Doo Ski Doo SUMMIT 2005 [815/1429] Lower arm

Ski-Doo Ski Doo SUMMIT 2005 [815/1429] Lower arm
Section 08 STEERING/FRONT SUSPENSION
Subsection 02 (FRONT SUSPENSION)
1
A33F27B
TYPICAL
1. Tab here to obstruct access hole
Upper Arm
When installing ball joint no. 15 to upper arm, en-
sure to tilt it with the proper angle as shown. The
ball joint housing must be parallel to ski leg tab.
This mounting position corresponds to 10° ±3°
angle from upper arm.
10° ± 3°
A33F2IB
Lower Arm
Position lower arm below anti-sway bar.
Prior to installing ball joint in lower arm, ensure to
clean the tapered surfaces with the pulley flange
cleaner (P/N 413 711 809). Surface contacts must
be clean and free of dirt, oil and grease. Apply
the cleaner on a rag then use the rag to clean the
surfaces of ball joint and ski leg.
To install ball joint, proceed as follows:
Install ball joint support (P/N 529 035 875) on
top side of lower arm (operating position).
Position ball joint installer (P/N 529 035 975) on
bottom side of lower arm (operating position).
Press ball joint in.
Install snap ring no. 13 with its opening toward
front of vehicle.
529 035 975
A33F29B
529 035 875
To properly torque ball joint nut, use the A-arm nut
wrench (P/N 529 035 876).
529 035 876
A33F2AA
Ensure to install the tool perpendicularly (90°)to
torque wrench.
mmr2005-142 301

Содержание