Ski-Doo Ski Doo SUMMIT 2005 [134/1429] Warning

Ski-Doo Ski Doo MX Z 2005 [134/1429] Warning
Section 03 ENGINES
Subsection 06 (BOTTOM END)
A32CB6A
Crankshaft Bearing Preparation
Heat up the bearing(s) using bearing heater
(P/N 529 035 969). This will expand bearings
and ease installation. If required, put a suitable
plate or shim to avoid the direct contact between
integrated seal (if applicable) with the heating
surface.
A32CB7A
CAUTION: Bearing should not be heated to
more than 80°C(176°F). Do not heat bearing
with direct flame or heat gun or heated oil.
Inappropriate heating procedure(s) may cause
inner seal failure.
Turn bearing(s) several times during heating
process for heating it (them) properly.
NOTE: Normally it takes approximately 10 min-
utes to heat up a bearing so in the event of replac-
ing bearing, its recommended to start the bearing
heating process prior to removal operation. Two
bearings can be heated at the same time on one
bearing heater.
A32CB8A
1
1. Bearings
Touch the inner race of the bearing with the tem-
perature indicator stick (P/N 529 035 970). Stick
will liquefy when the bearing reach the proper
temperature.
A32CB9A
WARNING
Do not touch heated bearing with bare hands.
Wear heat resisting gloves before handling
the heated bearing(s).
114 mmr2005-073

Содержание