Zyxel VES-1624FT-55A [190/312] Ves 1624ft 55a user s guide

Chapter 32 PPPoA to PPPoE

VES-1624FT-55A User’s Guide

190

Figure 103 PPPoA to PPPoE

The following table describes the labels in this screen.

Table 65 PPPoA to PPPoE

LABEL DESCRIPTION

Port Use this drop-down list box to select a port for which you wish to set up PPPoA

to PPPoE conversions. This field is read-only once you click on a port number

below.

VPI Type the Virtual Path Identifier for a channel on this port.

VCI Type the Virtual Circuit Identifier for a channel on this port.

IPQos Profile Select an IPQoS profile to classify and prioritize application traffic flowing

through this PVC. Use the Basic Setting > xDSL Profiles Setup > IPQos

Profile screen to configure IPQoS profiles. See Section 17.2 on page 119.

Encap Select an encapsulation method (llc or vc) for this PVC.

PVID Type a PVID (Port VLAN ID) to assign to untagged frames received on this

channel.

Note: Make sure the VID is not already used for multicast VLAN

or TLS PVC.

Priority Use the drop-down list box to select the priority value (0 to 7) to add to incoming

frames without a (IEEE 802.1p) priority tag.

AC Name This field is optional. Specify the hostname of a remote access concentrator if

there are two access concentrators (or BRAS) on the network or if you want to

allow PAE translation to the specified access concentrator. In this case, the IP

DSLAM checks the AC name field in the BRAS's reply PDU. If there is a

mismatch, the IP DSLAM drops this PDU. (This is not recorded as an PPPoE

AC System Error in the PPPoA to PPPoE Status screen, however.)

Service Name This field is optional. Specify the name of the service that uses this PVC. This

must be a service name that you configure on the remote access concentrator.

Hello Time Specify the timeout, in seconds, for the PPPoE session. Enter 0 if there is no

timeout.