Zyxel VES-1624FT-55A [191/312] Pppoa to pppoe status screen

Chapter 32 PPPoA to PPPoE

VES-1624FT-55A User’s Guide

191

32.3 PPPoA to PPPoE Status Screen

Use this screen to look at the current status of each PPPoA to PPPoE conversion. To open this

screen, click Advanced Application > PPPoA to PPPoE, and then click an index number.

Apply Click this to add or save channel settings on the selected port.

This saves your changes to the IP DSLAM’s volatile memory. The IP DSLAM

loses these changes if it is turned off or loses power, so use the Config Save

link on the navigation panel to save your changes to the non-volatile memory

when you are done configuring.

Cancel Click Cancel to start configuring the screen again.

Show Port Select which xDSL port(s) for which to display PPPoA to PPPoE conversion

settings.

Index This field displays the number of the PVC. Click a PVC’s index number to open

the screen where you can look at the current status of this PPPoA-to-PPPoE

conversion. (See Section 32.3 on page 191.)

Note: At the time of writing, you cannot edit the VPI and VCI. If

you want to change them, add a new PVC with the desired

settings. Then, delete any unwanted PVCs.

Port This field displays the number of the xDSL port on which the PVC is configured.

VPI/VCI This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier

(VCI). The VPI and VCI identify a channel on this port.

PVID This is the PVID (Port VLAN ID) assigned to untagged frames or priority frames

(0 VID) received on this channel.

Priority This is the priority value (0 to 7) added to incoming frames without a (IEEE

802.1p) priority tag.

Encap This field displays the encapsulation method (llc or vc) applied on the PPPoA-

to-PPPoE conversion.

Hello Time This field displays the timeout for the PPPoE session, in seconds.

IPQos Profile This field display the IPQoS profile applied on the PPPoA-to-PPPoE conversion.

Access Concentrator

Name

This field displays the name of the specified remote access concentrator, if any.

Service Name This field displays the name of the service that uses this PVC on the remote

access concentrator.

Select

Delete

Select the check box in the Select column for an entry, and click Delete to

remove the entry.

Select All Click this to select all entries in the table.

Select None Click this to un-select all entries in the table.

Table 65 PPPoA to PPPoE (continued)

LABEL DESCRIPTION