ECS Elitegroup KA1 MVP [23/85] Connecting ide floppy sata device

2-4

2.6 Connecting IDE, Floppy & SATA Device

1. If installing two IDE devices on the same

ribbon cable, one device must be set to

“master” and the other to “slave.” Check

the accompanying documents for the

master/slave settings of IDE Devices, ie.:

the hard disk and CD-ROM drives and then

set their jumper caps accordingly.

2. Mount the drives in the case.

3. Connect the floppy disk ribbon cable and

power cable.

4. Connect the IDE ribbon cable and power

cable.

IDE Hard Disk

Floppy Disk Device

SATA Hard Disk

2.7 Installing Expansion cards

1. Open the chassis and then remove the slot bracket from the case

where you will be installing the expansion cards.

2. Install your graphics card in the proper slot by pressing the card

firmly into the slot.

3. Drive in the screw to secure the slot bracket of the expanson card.

4. Replace your computer’s chassis cover.

5. Power on the computer, if necessary, set up BIOS utility of

expansion card from BIOS.

6. Install related driver to complete the installation.

Installing two graphics cards

Notes: 1. With one PCI Express Graphics card, install it into PCIEX16_1 slot, and

insert the “SHUNT CARD” into the PCIEX16_2 slot. With two PCI

Express Graphics cards, set them up onto PCIEX16_1 and PCIEX16_2

slots, and then plug in the external cable to unite the multi-GPU for CrossFire

mode.

2. For CrossFire

mode, a compatible Radeon graphics card and a related Radeon

CrossFire Edition co-processor board are needed.

Installing one graphics card