Lainox CEV026S+LD25 [36/50] Descaling the boiler if present
![Lainox CEV026S+LD25 [36/50] Descaling the boiler if present](/views2/1321750/page36/bg24.png)
36
26 • DESCALING THE BOILER (if present)
The appliance can count the functioning
hours of the steam generator and therefore
inform the operator when it is necessary to
activate de-scaling of the steam generator
via the special cycle [dE].
When the appliance is switched off, the
display 7 shows the [dE] message and
display 9 shows the days missing until
recommended de-scaling of the boiler,
indicated by the [dE End] message.
NOTE:Display9indicatestheDAYSmissing
until the appearance of the [dE End]
message.
The message starts to appear 15 days
before the appearance of the [dE End]
message.
The [dE End] message does not stop the
appliance definitively for obvious service
reasons. It is however recommended to
activate the [dE] program as soon as
possible after the appearance of the [dE
End] message.
To check the amount of hours missing until
the appearance of the [dE End] message,
with the appliance live and display off,
press button 6. The display 7 shows [USb],
turn knob 8 until [hrS] is displayed, press
the knob to confirm the selection.
The display 7 shows [P00], turn knob 8
until the display shows [dE]. The display
9 shows the hours missing until the
appearance of the [dE End] message.
The presence of scale causes loss of power
in the steam circuit and serious damage to
the steam generator.
Note that the steam generator runs a drain
and wash cycle automatically every day so
as to regenerate the water in it. Descaling
frequency is defined by several parameters
entered on the electronic card by the
technician at the time of installation on the
basis of the characteristics of the supply
water (upstream from the softener) and on
the basis of its technical characteristics.
The end of the [dE] descaling cycle permits
resetting the total number of hours and the
removal of the message: to permit this
operation, disconnect the oven from the
electric mains for a few seconds after the
end of the descaling program.
Descaling should be performed with the
appliance cold and clean (see “Daily
Cleaning”), preferably with the assistance
of the authorized technician.
Activation of de-scaling cycle [dE]
With the appliance live and display off, press
button 6. The display 7 shows [USb], turn
knob 8 until [bOI] is displayed, press the
knob to confirm the selection.
The displays 7 and 9 show [CAL Out]. Turn
the knob 8 until display 7 shows [dE].
Press button 15 to activate the de-scaling
cycle [dE].
The display shows [Att] wait, the automatic
operations of boiler draining and washing
are activated, then [dEt In] appears with
a cyclical audible warning telling the
operator to add the descaling agent after
unscrewing the cap A (the dilution per litre,
if necessary, should be done following
the directions of the manufacturer of the
product), observing the capacity of the
boiler,seetable:
Close the cap “A”.
Models
6 x GN 1/1
8 x GN 1/1
7 x GN 2/1
10 x GN 1/1
10 x GN 2/1
2.5
2.5
4
4
6
3.5
3.5
11
11
12.5
20 x GN 1/1
20 x GN 2/1
6
20.5
18
30
Litres Litres
GAS ELECTRIC
A
90026410rev01
Содержание
- C o m pa c t 1
- Capacity 2
- Models 2
- Contents 3
- Versions 3
- General reminders 4
- Caution no cooking with alcohol added is 5
- Permitted 5
- Points to remember 5
- Automatic humidity control key key 12 6
- Description of keys 6
- Description of keys 7
- Oven light key key 14 7
- Oven steam extraction vent key key 13 7
- A set the time 8
- B set core probe 8
- Cooking mode selection 8
- Manual settings for one phase cooking 8
- Set the temperature 8
- Switch on 8
- End of cooking 9
- Manual settings for one phase cooking 9
- A set the time for cycle 1 10
- B set the core probe for cycle 1 10
- Manual settings for cooking with up to 4 cycles in sequence 10
- Select 10
- Select cycle 2 and the following ones 10
- Set the temperature of cycle 1 10
- Switch on 10
- Up to 4 cycles up to 4 cycles 10
- End of cooking 11
- Manual settings for cooking with up to 4 cycles in sequence 11
- A set the time of cycle 1 12
- B set the core probe for cycle 1 12
- Entering and saving a program 12
- Saving the program 12
- Select 12
- Select cycle 2 and the following ones 12
- Select the program 12
- Set the temperature of cycle 1 12
- Switch on the oven 12
- Up to 4 cycles up to 4 cycles 12
- Retrieve 13
- Selecting and starting a saved program 13
- Switch on 13
- Deleting a saved program 14
- Foreword 14
- Retrieve 14
- Switch on 14
- Temporarily altering a saved program 14
- Copyingapresetrecipe 15
- Retrieve 15
- Selectingandstartingapre storedrecipe 15
- Switch on 15
- Foreword 16
- Temporarily changing a stored recipe 16
- Cooking with core probe 17
- Foreword 17
- Practical example 17
- Setting setting 17
- Setting the core probe 17
- What happens 17
- No yes no yes 18
- Setting the core probe 18
- Yes yes 18
- Automatic humidity control system 19
- Cooking with the automatic humidity control system 19
- Foreword 19
- Particular programs 20
- Particular programs 21
- Fa c t o ry s e t p r e s t o r e d regeneration programs 22
- Particular programs 22
- Reheat program foreword 22
- Changing the settings during the cooking phase 23
- Displaying settings during cooking phase without stopping 23
- Foreword 23
- Operating details 23
- Permanent stop 23
- Temporary stop 23
- Without stopping without stopping 23
- Caution no cooking with alcohol added is permitted 24
- Useful tips 24
- Non routine maintenance 25
- Periodically 25
- Prolonged disuse 25
- Routine maintenance 25
- Setting the date and time 26
- Download haccp log 27
- Import export recipes 28
- Ovens with steam generator ovens with direct steam 29
- Special programs 29
- Calout if present 30
- Special programs 30
- Mc cal hc cal if present 31
- Special programs 31
- Manual and automatic cleaning 32
- Special programs 32
- Manual cleaning 33
- Special programs 33
- Special programs 34
- Washing kit 34
- Special programs 35
- Washing kit 35
- Descaling the boiler if present 36
- Descaling action 37
- Descaling the boiler if present 37
- Self diagnosis and fault identification 38
- No h2o 39
- Self diagnosis and fault identification 39
- The main fault warning messages are 39
- Cal end 40
- De end 40
- Drn err 40
- Err det 40
- Err l1 err l2 err l3 40
- No boi 40
- No drn 40
- Self diagnosis and fault identification 40
- The main fault warning messages are 40
- Att off 41
- Err brx 41
- Err fbc err fbb 41
- No gas 41
- Self diagnosis and fault identification 41
- The main fault warning messages are 41
- Warning for gas models 41
- Pre storedrecipes 42
- Note recipes with core probe are only displayed if the oven is actually equipped with a core probe 43
- Pre storedrecipes 43
- La90026410 48
- Manuale uso compact en 48
- Description of display and keys 50
- Version s 50
Похожие устройства
- Lainox CEV026S+LD25 Руководство по монтажу
- Lainox CEV026S+LD25 Инструкция по технике безопасности (англ.)
- Lainox CEV026S+LD25 Конструкция (англ.)
- Lainox CEV026S+LD25 Электрическая схема
- Hallde RG-50 Инструкция по эксплуатации
- Hallde SB-4 Инструкция по эксплуатации
- Hallde VCB-61 Инструкция по эксплуатации
- Hallde RG-250 400В Инструкция по эксплуатации
- Hallde RG-350 230В + бункер непрерывной подачи Инструкция по эксплуатации
- Hallde RG-350 230В + устройство ручной подачи Инструкция по эксплуатации
- Hallde RG-50S Инструкция по эксплуатации
- Hallde RG-50S Каталог оборудования Hallde
- Hallde RG-250 230В Инструкция по эксплуатации
- Hallde CC-32 Инструкция по эксплуатации
- Hallde VCM-42 Инструкция по эксплуатации
- Hallde VCM-41 Инструкция по эксплуатации
- Hallde CC-34 Инструкция по эксплуатации
- Hallde RG-100 380В Инструкция по эксплуатации
- Hallde RG-350 400В + бункер непрерывной подачи Инструкция по эксплуатации
- Hallde RG-350 400В + устройство ручной подачи Инструкция по эксплуатации