Trotec Speedy 500 Инструкция по эксплуатации онлайн [39/61] 338813

8023 | V5.0_EN (11/2015)

Technical changes reserved

 Trotec Laser GmbH

Page 39 of 61

Also consult the Software Manual for further information.

5. Select "File Print", to access the printer driver, where you can perform work piece and

material settings as well as specify a job name or a job number.

This file is automatically transferred into Trotec JobControl.

6. After the material, the engraving direction, die orientation of the work piece and the

orientation of the plate have been specified in the Trotec JobControl under "Plate, Setup

Plate", the job can be positioned on the plate with a double-click. If necessary, the job can be

positioned at any position on the plate by dragging with the mouse. The position of the job

corresponds with the engraving position on the working table.

Make sure when engraving flammable materials the air assist is on!

7. Establish a connection with the engraver by clicking on the button "Establish

Connection" in JobControl.

8. Switch on the exhaust system. When using an original Trotec exhaust system with

installed connection cable, this happens automatically - check only, whether in the indicator

"Exhaust Ready" is green in the Engraver Control of the JobControl.

9. Finally press the START button (green arrow) in the Control of the JobControl, to

start the engraving process.

10. While the laser is working, you can generate the next graphic.

11. When the working is complete, the JobControl offers you the following possibilities:

 delete the job

 Job Reset and placing back in to the waiting list for later repeat of the working.

 Job Reset and immediate repeat