Qtech QSW-2910-09T-POE-AC/DC [25/212] Manage switch by telnet

+7(495) 797-3311 www.qtech.ru

Москва, Новозаводская ул., 18, стр. 1

Press enter button to make saved configuration be effective, and

press CTRL+C to restore system default configuration.

Step 6: Administrator can use stop connection when overtime, while normal user can use this

function in user mode. Input timeout command to configure the overtime of user’s logging in to

be 20 minutes. And use no timeout command to configure overtime to be non-over timing.

Step 7: Input following command after finishing operation to switch:

QTECH#quit

It is used to exit user interface.

1.4.2 Manage switch by telnet

Step 1: Establish configuration environment by connecting computer by network to switch

interface;

Step 2: Run Telnet program in computer;

Step 3: After switch is power on, input switch IP address to connect to switch, and input

configured logging in password according to the prompt, then the command line prompt is

displayed (such as QTECH>). It will be disconnected after 1 minute when there is not any input

before successfully logging in or wrong inputting of user name and password for 5 times. If

there is such prompt as ―Sorry, session limit reached.‖, please connect later (At most 2 telnet

users are allowed to log in at the same time.);

Step 4: Use related command to configure switch system parameter or view switch operation.

If you want to enter privileged mode, user must possess the privilege of administrator. If you

need any help, please input ―?‖ at any moment. For concrete command, please refer to

following chapters.

Step 5: If you want to exit telnet, use quit or exit command to exit in user mode, and quit

command or ―ctrl+]‖ to exit in other mode. Administrator can use stop username command in

privileged mode to exit logging in.