Qtech QSW-2910-09T-POE-AC/DC [28/212] Interface prioruty configuration

+7(495) 797-3311 www.qtech.ru

Москва, Новозаводская ул., 18, стр. 1

 Command form in interface mode

speed { 10 | 10auto | 100 | 100 auto | 1000 | 1000 auto | auto }

no speed

duplex { auto | full | half }

no duplex

For example:

!Configure the speed of Ethernet 0/1 to 100Mbps and duplex mode to be

full duplex

QTECH(config-if-ethernet-0/1)#speed 100

QTECH(config-if-ethernet-0/1)#duplex full

In system, if one of speed and duplex is set to be auto, the other will also be auto.

2.2.6 Interface Prioruty Configuration

There are 8 priorities from 0 to 7, and the default interface priority is 0. The larger the priority

value is, the higher the priority is. And the packet with the higher priority will be quickly handled.

If there are too much packet to be handled in some interface or the packet is urgent to be

handled, priority of this interface can be configured to be high-priority.

Use following command in interface configuration mode:

 Configure priority of Ethernet 0/5 to be 1

QTECH(config-if-ethernet-0/5)#priority 1

 Restore the default priority of Ethernet 0/5

QTECH(config-if-ethernet-0/5)#no priority

2.2.7 Interface description configuration

Use following command to describe interface to distinguish each interface from others.

Configure it in interface configuration mode.

description description-list

For example:

!Configure description string “test” for the Ethernet 0/3

QTECH(config-if-ethernet-0/3)#description test

!Display description of Ethernet 0/3

QTECH(config)#show description interface ethernet 0/3

2.2.8 Ingress/egress bandwidth-control configuration

Egress/ingress bandwidth-control is to restrict the total speed rate of all sending and receiving

packets.