Qtech QSW-2910-09T-POE-AC/DC — настройка и управление тревогами интерфейсов сети [42/212]

Превью страниц Страница 42 / 212

+7(495) 797-3311 www.qtech.ru

Москва, Новозаводская ул., 18, стр. 1

alarm all-packets threshold [ exeed exceed ] [ normal normal ]

Caution: Exceed > normal. By default, 100 BASE exceed threshold is 85,normal threshold is

For example:

!Configure alarm all-packets exceed threshold to be 500,and normal

threshold to be 300

QTECH(config)#alarm all-packets threshold exceed 500 normal 300

2.6.6 Display port alarm

 Input following command in any configuration mode to display global interface alarm:

show alarm all-packets

For example:

!Display global alarm all-packets information

QTECH(config)#show alarm all-packets interface ethernet 0/0/1

 Input following command in any configuration mode to display interface alarm on the

port:

show alarm all-packets interface [ interface-list ]

Keyword ―interface-list‖ is alternative. If there is no keyword, the alarm all-packets of all the

interfaces are displayed, or the information of specified port is displayed.

For example:

!Display the alarm all-packets interface information of Ethernet

0/0/1

QTECH(config)#show alarm all-packets interface ethernet 0/0/1

e0/1 port alarm information

Port alarm status : enable

Port alarm exceed threshold(Mbps) : 85

Port alarm normal threshold(Mbps) : 60

Total entries: 1.0

2.7 Interface shutdown-control Configuration

2.7.1 Brief introduction of shutdown-control

Interface shutdown-control is used to restrict the speed rate of unicast\ multicast\broadcast of

single interface. If the rate is beyond the configured restricted value(that can be configured),