Qtech QSW-2910-09T-POE-AC/DC [34/212] Port lacp convergent configuration

+7(495) 797-3311 www.qtech.ru

Москва, Новозаводская ул., 18, стр. 1

including monitor port and mirrored port list. Use this command in any configuration mode:

show mirror

For example:

!Display monitor port and mirrored port list

QTECH#show mirror

2.3.2.4 Delete all port and traffic mirror

Delete all port and traffic mirror:

no mirror all

For example:

!Delete all port and traffic mirror

QTECH(config)#no mirror all

2.4 Port LACP convergent configuration

2.4.1 Brief introduction of port convergence

Port convergence is a channel group formed by many ports convergence to realize flow load

sharing for each member. When a link cannot be used, flow of this link will be transferred to

another link to guarantee the smoothness of the flow.

Basic configurations are:

1. static or dynamic channel groups can be configured and at most 12 interface members can

be configured in each group, and at most 8 interfaces can be convergent at the same time

in each group which is determined by up/down status, interface number, LACP priority.

Each group is defined to be a channel group, and the command line is configured around it.

2. Load balance strategy of each group can be divided into source MAC, destination MAC,

source and destination MAC, source IP, destination IP, and source and destination IP. The

default strategy is source MAC.

3. System and interface LACP priority can be configured. The default system priority is

32768,and interface priority is 128. To remove system and interface priority is to restore

them to default ones.

4. LACP protocol of each interface can be configured. In static mode, interface is static

convergent, and LACP protocol does not run; in active mode, interface will initiate LACP

negotiation actively; in passive mode, interface only can response LACP negotiation. When

interconnecting with other device, static mode only can interconnect with static mode;